Jump to content
SAU Community

Recommended Posts

I heard them call it the R35 GTR but it is actually a "Nissan GTR" there is no such thing as a R35.

Someone better tell Nissan that one Stirls, so they can remove the NISSAN ID PLATE number for the 07- GTR that goes R35-000XXXX (XXXX being the build number of the car)..... :P

Edited by Martin Donnon

for those not doing anything today (and not goin to the race)

havin a bbq at mine to watch the race

bring drink, bring meat.........i supply bbq, plasma and fridge

starts from 12............giv me a holler if ya coming :P

Just want everyone to know, Battlestar Galactica is the greatest show ever... now that I have that off my chest...

You watched the 2nd part of Daybreak? How bloody awesome was it....

I haven't seen a series with such thorough writing since Babylon 5.... the way the wrapped up all the plot arcs at the end was unreal, I was sitting there lmfao at some of the turns during that last episode...

BSG FTMFW

-D

hung.the.fuck.over :P

Haven't drank properly for like 2 months after getting smashed every weekend for the better part of 3 years, fk I'm feelin it today. Bulk amount of Powerade will be consumed at work this arvo I imagine.

Edited by AndrewJZX100
Someone better tell Nissan that one Stirls, so they can remove the NISSAN ID PLATE number for the 07- GTR that goes R35-000XXXX (XXXX being the build number of the car)..... :down:

yeah I think Dale may have been referring to the name "Skyline"

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...