Jump to content
SAU Community

Recommended Posts

my bet is they saw the defect sticker and thought hey lets pull him over and let him know his cars defected.....when i had a defect on my car it was like a freaking homing beacon to them get pulled over everytime just for them to say did you know your cars defected? nah ohrly couldnt see the two bright yellow stickers right in front of me......

/rant

Was just a check to see how long I have to drive it. Was 3 chick cops to, but damm they were fine. Can stop me anyday.

On a amercian muscle car cruise and just had a car bouncing down the rd on hydros. U can smell the methonal mmmm

Was just a check to see how long I have to drive it. Was 3 chick cops to, but damm they were fine. Can stop me anyday.

"i dont have a backseat, but if youre flexible, ive got some awesome monkey bars."

Was just a check to see how long I have to drive it. Was 3 chick cops to, but damm they were fine. Can stop me anyday.

On a amercian muscle car cruise and just had a car bouncing down the rd on hydros. U can smell the methonal mmmm

I was chased by a cop on foot down Hindley st once cos he saw a defect sticker on my skyline, i was only defected about 10 minutes before :ermm:

Watching Bathurst, just spotted blue mesh on car 34, had a bit of a chuckle!

Its becoming famous :)

Also ... someone keeps calling my mobile when I'm not near it and I'm missing the call (mostly when I'm driving). Number comes up as "unknown" so I can't call you back. If its anyone from here, can you SMS me your number and I'll return your call. Thanks.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...