Jump to content
SAU Community

Recommended Posts

or buy a more expensive filter if price is no option

the foam on those HKS ones gets a bit crumbly at times . hence why I am not a big fan of em

Well it has a HKS kit on it now; so it's not really cheap. I'm only looking for the filter itself and not the kit.

I've found a place I can buy the HKS replacement filter, so its all good.

Will have to see how to goes once I get them tomorrow. :thumbsup:

The temperature is fine; everything seems to be fine other than the original issue.

I think it's AFM. Waiting on filters, I will have to see how it goes once I can replace these.

One AFM's sensor had alot of grease or dirt on it, due to most likely a bad air filter.

Hopefully it will be fixed after I replace the filters.

I've cleaned out the AFM, replaced the filters. I knew the filters wouldn't be the cause; I thought the oil etc in the AFM sensor might have been caused by the worn air filter.

It seems to have fixed it to some extent; but I'm still having some problems :P

It doesn't not have exactly the same issue after cleaning the AFM, replacing the filters.

Now intermittently it will seem to lose power for a very short time. Maybe 1-3 seconds, almost like its missing but I don't think it is actually missing. It's similiar to the previous issue, it feels the same. When it starts having the issue, if I accelerate it will go back to normal. One time I stopped at the lights it stalled as well. This issue usually happens when I'm just driving along, not accelerating.

Also, sometimes when I first start it(when its cold) it will rev up and down. This is intermittent too, usually will drop to about 300 or so revs the just back up to 1100 or so then go back to 900 and it will be fine.

I've also noticed the oil pressure seems to run high when its cold, around 7 on the metre. Once it warms up, it's ok, sits around 4.

If I boost it for abit when its warmed up, it will go higher. I thought this was normal; it always went up abit when I'm in boost before having these problems. Just now after having these problems it seems to have high oil pressure when its cold.

I have not noticed it doing the exactly the same issue where as before it wouldn't rev over 1000 or 2000 revs, so thats why I think its fixed to some extent.

Any ideas for these other issues would be great.

Thanks :P

It seems to be going back to the original issue now, was not as bad when I put the AFM's and filters back in.

But today it's happened several times in a span of 30mins or so.

I don't think it is a solder issue with the AFM; I've already pulled the AFM's apart and the solder is fine. I think if it is the AFM, its purely faulty and not anything to do with bad solder points.

It's just when it starts happening I'll usually pull over, turn the car off and back on again, then it will be fine.

I think there's a good chance it's something like a hole in one of the hoses. Although difficult to tell, but if its a pin hole or something. This could explain the intermittent issue, maybe occasionally the hose moves and causes the hole to open. Other than this I'm not sure.

My friend said his car had exactly the same problem. There was a crack in one of the hoses. Although I've checked the hoses already, I'll try doing a more thorough check. Or just replace them...

Thanks alot, appreciate your help :cheers:

Edited by Line
  • 2 weeks later...

I've changed the AFM's. Not new AFM's; out of another GTR. Which apparently were working fine when they were in the car, this was some years ago though.

Anyway, after replacing the AFM's. It seems to have stopped the original issue. After 4 days with different AFM's I have not experienced the original issue once. But now there's another problem...

Very intermittent; happened about twice over the past 4 days.

First time it happened; I was driving along about 90km's...not accelerating.

My car felt like it was jerking slightly, I kept on driving and came to some lights it seemed to have stopped. After this it was fine.

Yesterday I started the car and it was idling a little rough, so I reved it up abit. Seems like it was hesitating to rev. I'd rev it to 2,000 or so it would drop down about 200 revs and then back up to normal.

I could rev higher no problem, but it would rev up and down 200 or so revs to where I had it set...

When its having this problem, theres no loss in power at all, its not missing or anything like that, just reving up and down by these small increments. :(

With the original issue, I found it would not rev higher than 2,500 no matter if foot to the floor.

I'm certain the original issue is gone with the different AFM's in.

So, I would assume there was something wrong with my original AFM's since it diplays a completely different problem with the AFM's changed.

The guy I borrowed the AFM's from had these sitting in his garage for a few years, he says they were working fine when they were last in a car.

Any ideas on this new problem? Do you think theres a possibility these new AFM's I've put in have something wrong with them?

It's just getting really annoying, its so intermittent. Very difficult to troubleshoot the cause :laugh:

Also taken it to a mechanic, but they were unable to fault it :D

Any ideas would be greatly appreciated, thanks.

Edited by Line

It sounds to me like you might have some water in your fuel, my motorbike used to behave the same way when it got water in it. Try adding some metho to your tank (most effective/cheap but I doubt it's the best thing in the world for your engine) or try some of that petrol treatment / cleaner, most service stations have it.

Have you checked / cleaned or changed the spark plugs?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
    • Oh, you are right. But, in Australia E10 is based on 91RON fuel and ends up being 94RON. Hence it being the cheaper option for economy cars. The more performance oriented cars go for the 98RON fuel that has no ethanol mixed in. The only step up we have left then at some petrol stations is E85.
    • There is a warning that "this thread is super old" but they ignore that anyway...
    • With 10% Ethanol, we're talking 2-3% fuel consumption difference. The emissions reductions and octane boost in my opinion far outweigh this almost non existent loss.    My tanks sitting at 80%. Luckily that should go down fast as I'm on vacation again for the next two weeks. 
×
×
  • Create New...