Jump to content
SAU Community

Recommended Posts

So,

After a moronic women named Shazza rear-ended my R32, im in the market for a good panel beater to get the bar repsprayed and re-aligned, fix the number plate lights etc, nothing too major. Can anyone recomend a good panel beater in the inner city Melbourne area, bare in mind i need 3 quotes to satisfy her insurance.

  • 8 months later...

AMEX PANELS in Fairfield is a really really good panel beater.

They do prestige cars all the time, and the work is exceptional.

They are expensive, so for insurance work they ar perfect, they also are affilliated with lawyers who deal only with car claims, so they can get a lot more done for your car, rather than just getting the damaged fixed....

They worked well for my gf's car.

BASS OUT

No, not dodgy.

Just instead of an insurance base company who will just fix the visual damage, this company will make sure everything around the damage is fixes.

Like if you had a front on, and the radiator got punctured, they will fit new hoses, probably a new pump as well in case shit got in and it dried up during repair.

If you damage your quarter panel, they will make sure the inner wheel arches are perfect and not just covered by the new quarter panel, and that the whole front end of the car is then properly aligned.

At the end of the day, it's the person who hit you's fault, so you should make sure your car is as good as it was before the damage, not just fixed.

BASS OUT

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...