Jump to content
SAU Community

Rda Rotor (& Ebc Pads) Group Buy Is Back In 2008!


Recommended Posts

all cleared, group buy sent off yesterday. today is public holiday in VIC so it may not be fully processed again until tomorrow, but that shouldn't be a problem.

  • Replies 548
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

If they're all in stock they can be shipped out of their warehouse as soon as wed or thu. but if I heard anything from them about anything that may be out of stock and may cause delay then I'll post it here.

Most likely front R32 Gtst rotors. Measure it then I'll know. Rears are the same.

If your front rotors is 280mm (28cm) diameter across then it's the R32 gtst rotors, rear should be 297mm across (close to 30cm).

If front is also 296mm (about 30cm) across then you've got the front R32 gtr rotors.

Update to Group Buy 40 :

1. Muz (payment cleared)

2. scorp (payment cleared)

3. SevenAngryPenguins (waiting for payment to clear)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
    • For DBA, check out their guide table here. https://dba.com.au/wp-content/uploads/2023/01/Direct_Replacement-Guide-2021.2.pdf   Additionally they have some other guides and info on how to make sure you choose the right pad.
×
×
  • Create New...