Jump to content
SAU Community

Verde Kaos Special

Taleb Tyres

By Taleb Tyres,
in For Sale (Business Traders)

 Share

Recommended Posts

Taleb Tyres Proficient

Taleb Tyres

Posted
Posted

We are now offering VERDE KAOS to SAU users at discounted prices.

BLACK/CHROME DISH

Tn_55kaos-blk-chrome.jpg

18" PACKAGE $1700(RRP $1900)

20" $2600(RRP $2900)

(18" fit GTS & GTR, 20" fit GTS ONLY)

CHROME

Tn_55kaos-chrome.jpg

18" PACKAGE $1600(RRP $1800)

20" $2400(RRP $2800)

(18" fit GTS ONLY, 20" fit GTS ONLY)

HYPER SILVER

Tn_55Kaos-hyp%20silver.jpg

18" PACKAGE $1300(RRP $1500)

20" $2100(RRP $2500)

(18" fit GTS ONLY, 20" fit GTS & GTR)

Tyre brands depend on sizes applicable

Link to comment
https://www.sau.com.au/forums/topic/202174-verde-kaos-special/
Share on other sites
Taleb Tyres Proficient

Taleb Tyres

Posted
  • Author
Posted
Hey mate im after some nankangs NS2 in 265/35r18 how much each PM if you want i need 4.

Hey mate we dont sell Nankang in that size, if your after cheap i have Kumho, can do them $200 ea fitted/balanced, otherwise $275 for 265/275 japanese tyres.

Taleb Tyres Proficient

Taleb Tyres

Posted
  • Author
Posted
what size width on front and rear wheels? offset? how big of the dish? (for 18" HYPER SILVER)

cheers

18X8 (one width) +20/38 offset

20X8.5 (one width) +20/38 offset

18" dish is approx 2"

  • 4 months later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      HR34 GT speedo issue

      By joshuaho96 · Posted

      Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Dylannn
      WTB RB25 Gearbox NSW / central west

      By Dylannn · Posted

      Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • SeanR32GtSt
      Hypergear Turbochargers and High flow Services Development thread

      By SeanR32GtSt · Posted

      Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
    • GTSBoy
      R34 Manual conversion Speedometer

      By GTSBoy · Posted

      He means "as opposed to mechanical cable drive". Older cars (R32 for ex.) had cable drive. Later cars with essentially the same gearbox, ie R34 GT (NA RB25) used essentially the same box as the R32 GTSt, but instead of a cable drive, had an electronic speed sender plugged into the same hole in the box, running from the same little gear that would have run the cable. Some of the shittier later cars use a speed sender on the nose of the diff, or the ABS sensors.
    • GTSBoy
      Hypergear Turbochargers and High flow Services Development thread

      By GTSBoy · Posted

      Lower than engine, or lower than it should at the hubs? Either way, that is a nice power figure and I'm not surprised you say it rips now. What stopped you from turning it up any more? Injectors? Or did it just stop responding to boost?
×
×
  • Create New...