Jump to content
SAU Community

Recommended Posts

after a few months of having a stock turbo in my 33 gtst ive repaired my hiflow turbo by mtq, im curious to see what opinions you guys come up with with my new setup in terms of power. the only thing ive changed is the pod setup as ive gone back to the stock panel system (k&n hiflow panel filter) and the old slide hiflow which is about 1mm bigger now

r33gtst

-hiflow turbo (1mm bigger than slide stage1 hiflow)

-pfc

-600cc inj

-bigger fuel pump

-fmic

-3in turbo back exhaust with hiflow cat

-z32 afm

- k&n hiflow panel filter in stock airbox this time. had pod last time. no cai

this time i will be running 1bar.

estimates?

and no you dont get a prize for guessing . lol

cheers :)

Edited by R33GOD
Link to comment
https://www.sau.com.au/forums/topic/202867-power-estimate-with-new-setup/
Share on other sites

same as most people

230-240rwkw. Its a high flow, you cant fit a much bigger front wheel into the thing and not impact the rear so your only ever going to get 230-260rwkw boost dependant. Just the usual result really.

this isnt a joke ppl lol.

i posted this because no one seems to have posted results on a MTQ hiflow. i tried searching for ages.

thing is you cant magically fit a wheel in there much bigger than what everyone else does.

so results are going to be marginal at best against the other hi-flows on the market

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'll just leave this with, holy shit, those cars at work are awesome, and this will look wicked!
    • Could you modify this duct so instead it pushes the extra air through the radiator too and not down and out? For temps, I know it's not the greatest idea, but as a bit of a last resort, you could use a very intermittent misting spray onto the front of the coolers/rad. You don't want to be soaking them such that water is dripping off, but a small most on/off so that the water evaporates. That point of it constantly evaporating, rather than being soaked in water, will pull a LOT of heat out of the cooler. I'm literally thinking just the little mist sprayers for a garden from Bunnings. Being in a low humidity climate it will help even more! The other trick if you want to be ghetto is some shade cloth hung in the opening, and keep it wet. Pretty much now it's acting like an evap cooler on a house, but cooling the air you need to use to cool the radiator...   On a topic to think about too though, when air enters through the bumper, is it all nicely ducted from the edges of that opening back at a nice angle, or is it like most cars, and the edge of the opening just stops, and suddenly it's wayyy wider behind that? If it does the later, get it shrouded out at nice angles. When that opening changes too rapidly, it can actually cause a high pressure zone between the front bar and radiator, and limit air flow into that area, which means less air for cooling, as it effectively stalls the air, AND adds to drag...
    • Do you have any before and after photos? That's $200 just for the hydro blasting?
    • It doesn't look like there's a lot of options out there these days, and what's out there is performance oriented aftermarket stuff (with the GTR markup) I wonder if there are other cars with similar springs, after all its just a matter of length, diameter and stiffness. Alternatively, I did see coil spacers. Probably not the best option, but could be serviceable too.  
×
×
  • Create New...