Jump to content
SAU Community

Recommended Posts

  • Replies 65
  • Created
  • Last Reply

Top Posters In This Topic

Never nice to hear about anyone being killed like that. But on the same note, karma seems to have popped its head up on this one.

Might sound a bit rough but Im glad to see it was 2 armed thieves and not some poor young family like it usually seems to be.

My 2c...

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3624537
Share on other sites

You get what you give me thinks. Thats why Ill let people out of side streets in stop start traffic and if thier lane is ending, to build up some good karma. These guys got bitch slapped by their own doings. They ran out of good vibes yo

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3624815
Share on other sites

Let this be a lesson to other scumbags that try to do this shit, i think justice was served the hard way.

I feel sorry for the guy they assaulted and the invesitgation the police will have to go through to justify there actions.

Edited by subzeroR33
Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3625108
Share on other sites

Think about what sort of people it takes to, in a premeditated fashion (If it was a single person I could believe it may have been heat-of-the-moment, but to work together requires some sort of planning), select a single vunerable person and take what he has worked hard to achieve purely out of jealousy in a blantant disregard for the law and the basic set of rules which make up civilization. To do this you need to be pretty much at the pond-scum level, society is better off without these two loosers, good ridence and I hope they realised that it was there own stupidity that got them killed the moment before the truck hit them.

No sympthay for them, nor for their families. If the parents were piss-poor enough to raise these two then they dont deserve it, if there partners (if they had any) were stupid enough for fall for them, same again. The only exception is any children they had, however the apple never falls far from the tree, so prehaps by some twist, this might actually enable the kids to grow up to be reasonable people.

However at 18 and 20, I doubt they had offspring, but you never know with these low-life scum types.

I feel sorry only for the owner of the car.

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3625698
Share on other sites

Fcuk them. They reap what they sowed. Too often the punishment is far too lenient but this time it was karma that played a part.

Time to stop feeling sorry for everyone associated with them. Life is full of crap. Suck it up and move on. Care for those you know and want to care about.

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3625800
Share on other sites

My honest opinion? I think they deserved to die. slowly. what if they guy they carjacked had said no? they would have stabbed him. he could have died. and it would have been slow. and painful. they deserved everything they got.

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3626093
Share on other sites

Good guys 2- bad guys 0! How many times do you read about drunks or people stoned killing innocent people on the roads? I come from a place where carjacking is a national sport, i don't wish death on anyone, i think they lived dangerously and it was only a matter of time.

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3626274
Share on other sites

seems like there is a lot of dickheads around.

unfortunately they all seem to be on this forum.

no point arguing this in much detail, as if you believe somebody deserves to die because they carjacked somebody at knife point, you are a dickhead. plain and simple. i am a social worker who works with teenagers and young adults (ages 12-24) currently in our criminal justice system on a daily basis, so have a fair idea of the backgrounds of some of these offenders, but reading the above statements, arguing on their behalf any further would be a waste of my and your time. this isn't a bleeding heart statement, where i believe all these people just need hugs and kisses to get over their problems and maybe a slap on the wrist. i personally think rapists, and child abusers should be hung with barb wire, by their genitals, but that's a whole different matter.

those two clowns made a mistake, but they sure as hell did not deserve to die for that mistake. i am sure that some of you will try to argue this, but in advance to these arguments here is my pre prepared counter argument: go fark yourself :D

Link to comment
https://www.sau.com.au/forums/topic/204562-your-opinion/#findComment-3626652
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Who did you have do the installation? I actually know someone who is VERY familiar with the AVS gear. The main point of contact though would be your installer.   Where are you based in NZ?
    • Look, realistically, those are some fairly chunky connectors and wires so it is a reasonably fair bet that that loom was involved in the redirection of the fuel pump and/or ECU/ignition power for the immobiliser. It's also fair to be that the new immobiliser is essentially the same thing as the old one, and so it probably needs the same stuff done to make it do what it has to do. Given that you are talking about a car that no-one else here is familiar with (I mean your exact car) and an alarm that I've never heard of before and so probably not many others are familiar with, and that some wire monkey has been messing with it out of our sight, it seems reasonable that the wire monkey should be fixing this.
    • Wheel alignment immediately. Not "when I get around to it". And further to what Duncan said - you cannot just put camber arms on and shorten them. You will introduce bump steer far in excess of what the car had with stock arms. You need adjustable tension arms and they need to be shortened also. The simplest approach is to shorten them the same % as the stock ones. This will not be correct or optimal, but it will be better than any other guess. The correct way to set the lengths of both arms is to use a properly built/set up bump steer gauge and trial and error the adjustments until you hit the camber you need and want and have minimum bump steer in the range of motion that the wheel is expected to travel. And what Duncan said about toe is also very true. And you cannot change the camber arm without also affecting toe. So when you have adjustable arms on the back of a Skyline, the car either needs to go to a talented wheel aligner (not your local tyre shop dropout), or you need to be able to do this stuff yourself at home. Guess which approach I have taken? I have built my own gear for camber, toe and bump steer measurement and I do all this on the flattest bit of concrete I have, with some shims under the tyres on one side to level the car.
    • Thought I would get some advice from others on this situation.    Relevant info: R33 GTS25t Link G4x ECU Walbro 255LPH w/ OEM FP Relay (No relay mod) Scenario: I accidentally messed up my old AVS S5 (rev.1) at the start of the year and the cars been immobilised. Also the siren BBU has completely failed; so I decided to upgrade it.  I got a newer AVS S5 (rev.2?) installed on Friday. The guy removed the old one and its immobilisers. Tried to start it; the car cranks but doesnt start.  The new one was installed and all the alarm functions seem to be working as they should; still wouldn't start Went to bed; got up on Friday morning and decided to have a look into the no start problem. Found the car completely dead.  Charged the battery; plugged it back in and found the brake lights were stuck on.  Unplugging the brake pedal switch the lights turn off. Plug it back in and theyre stuck on again. I tested the switch (continuity test and resistance); all looks good (0-1kohm).  On talking to AVS; found its because of the rubber stopper on the brake pedal; sure enough the middle of it is missing so have ordered a new one. One of those wear items; which was confusing what was going on However when I try unplugging the STOP Light fuses (under the dash and under the hood) the brake light still stays on. Should those fuses not cut the brake light circuit?  I then checked the ECU; FP Speed Error.  Testing the pump again; I can hear the relay clicking every time I switch it to ON. I unplugged the pump and put the multimeter across the plug. No continuity; im seeing 0.6V (ECU signal?) and when it switches the relay I think its like 20mA or 200mA). Not seeing 12.4V / 7-9A. As far as I know; the Fuel Pump was wired through one of the immobiliser relays on the old alarm.  He pulled some thick gauged harness out with the old alarm wiring; which looks to me like it was to bridge connections into the immobilisers? Before it got immobilised it was running just fine.  Im at a loss to why the FP is getting no voltage; I thought maybe the FP was faulty (even though I havent even done 50km on the new pump) but no voltage at the harness plug.  Questions: Could it be he didnt reconnect the fuel pump when testing it after the old alarm removal (before installing the new alarm)?  Is this a case of bridging to the brake lights instead of the fuel pump circuit? It's a bit beyond me as I dont do a lot with electrical; so have tried my best to diagnose what I think seems to make sense.  Seeking advice if theres for sure an issue with the alarm install to get him back here; or if I do infact, need an auto electrician to diagnose it. 
    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
×
×
  • Create New...