Jump to content
SAU Community

Recommended Posts

Can anyone tell me roughly how many k's I should get out of a full tank of fuel in a 97 RS4 Stagea in standard form.

I have just clocked my last ful tank at 360k's which seems very low?

If this is the can fault coil packs cause this high consumption as the car does not appear to be running rich. However I do have this pulsing problem over 70kmh as posted on another thread.

Does anyone have any ideas

Cheers

Bakes70

Link to comment
https://www.sau.com.au/forums/topic/205752-fuel-consumption/
Share on other sites

  • Replies 70
  • Created
  • Last Reply

Top Posters In This Topic

ok when I bought my stag the SAFCII hadn't been tuned and I was getting around 400 per tank city driving and well over 500 per tank on the open highway (drove from SA to WA)

With it tuned now, I get 460 per tank... city driving.

I've got 345 on the clock with just over a quarter of a tank to go and I'll get atleast another 100km from it.

Thats on BP Ultimate (98ron)

Edited by StageaGirl
ok when I bought my stag the SAFCII hadn't been tuned and I was getting around 400 per tank city driving and well over 500 per tank on the open highway (drove from SA to WA)

With it tuned now, I get 460 per tank... city driving.

I've got 345 on the clock with just over a quarter of a tank to go and I'll get atleast another 100km from it.

Thats on BP Ultimate (98ron)

Thanks for that. I have a stupid question now what is the SAFCII?

Also are you in Rockingham, Perth by any chance...if so were did you take your car to get tuned.

Cheers

Bakes70

i had shot coilpacks with my rb25. they gave chronic misfire on full throttle at 4000rpm and above. however this made me drive the car nicely so i still retained great economy.

remember it also matters how you drive it, i can get 20% better economy if i'm nice to my car.

check your 02 sensor, they're meant to be replaced every 40 000kms iirc

and google SAFCII to find out HEAPS of info :D

bugger all mate, even when working perfectly they are thirsty if your foot is heavy.

and mine is. really heavy.

mine is manual, new 02 sensor, airfilter and exhaust on the standard computer, and I am happy if I get 400klm.

About to put a power fc in and see if that helps, but I'm not expecting an improvement

360km isnt bad, honestly.

when I first got mine I got around 410kms per tank to around 55L

then tuned, a little less kms but more power

and again

and again

now Im limited to 90kms per quarter if I pussyfoot for 80% of the tank

the other 20% makes it worth it :laughing-smiley-014:

360km isnt bad, honestly.

when I first got mine I got around 410kms per tank to around 55L

then tuned, a little less kms but more power

and again

and again

now Im limited to 90kms per quarter if I pussyfoot for 80% of the tank

the other 20% makes it worth it :laughing-smiley-014:

Cheers for that. I just wanted to get a handle on how thristy they are, and if my problem was fuel related.

yeah I'm in Rockingham... I took my car to Hyper drive when I first got the car.

I also run 7-9psi now too, instead of 12 lol

Super Air Flow Controller (SAFC) it modifies the air flow meter signal to trick the ECU into thinking that there is less air going in to the engine, to send in less fuel, as the stock ECU tends to run quite rich with mods. (all that info from Mitchy)

yeah I'm in Rockingham... I took my car to Hyper drive when I first got the car.

I also run 7-9psi now too, instead of 12 lol

Super Air Flow Controller (SAFC) it modifies the air flow meter signal to trick the ECU into thinking that there is less air going in to the engine, to send in less fuel, as the stock ECU tends to run quite rich with mods. (all that info from Mitchy)

I am in Rockingham too......I am running just under 7psi boost but everything else is pritty standard. Do you know anywere local that could tune the SAFC on my car.

Cheers

Paul

SAFCs will have minimal effect on your economy, as when you are cruising (closed loop) the ECU reads the O2 sensor and constantly adjusts to achieve the preset mixture. The SAFC will save you some fuel when you are hard on the throttle (open loop), where it uses the air flow meter signal. A lot of tuners won't even bother to tune the low throttle map on the SAFCs, as mine did.

http://www.hondahookup.com/forums/showthread.php?t=92218

Other than an aftermarket ECU the best thing to do is make sure your engine is running as efficient as possible, ie new platinum plugs, new fuel filter and pump, new air filter, new O2 sensor, splitfire coil packs and drive 'off boost' whenever possible.

you could try X-Speed in o'connor. There is noone in rockingham, only ford/holden specialists... and I wouldn't trust them to even know what a Stagea is lol

You could try GTi Performance too in Bibra Lake...ask for Simon, I'm not sure if he does SAFC's though. He is a nice guy and owns an S15 or two lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I thought that might be the case, thats what I'll start saving for. Thanks for the info 
    • Ps i found the below forum and it seems to be the same scenario Im dealing with. Going to check my ECU coolant temp wire tomorrow    From NICOclub forum: s1 RB25det flooding at start up Thu Apr 11, 2013 7:23 am I am completely lost on this. Car ran perfectly fine when I parked it at the end of the year. I took the engine out and painted the engine bay, and put a fuel cell with an inline walbro 255 instead of the in tank unit I had last year. After reinstalling everything, the engine floods when the fuel pump primes. if i pull the fuel pump fuse it'll start, and as soon as I put the fuse back in it starts running ridiculously rich. I checked the tps voltage, and its fine. Cleaned the maf as it had some dust from sitting on a shelf all winter, fuel pressure is correct while running, but wont fire until there is less than 5psi in the lines. The fuel lines are run correctly. I have found a few threads with the same problem but no actual explanation of what fixed it, the threads just ended. Any help would be appreciated. Rb25det s1 walbro255 fuel pump nismo fpr holset hx35 turbo fmic 3" exhaust freddy intake manifold q45tb q45 maf   Re: s1 RB25det flooding at start up Fri Apr 12, 2013 5:07 am No, I didn't. I found the problem though. There was a break in one of the ecu coolant temp sensor wires. Once it was repaired it fired right up with no problems. I would have never thought a non working coolant temp sensor would have caused such an issue.
    • Hi sorry late reply I didnt get a chance to take any pics (my mechanics on the other side of the city) but the plugs were fouled from being too rich. I noticed the MAF wasn't genuine, so I replaced it with a genuine green label unit. I also swapped in a different ignitor, but the issue remains. I've narrowed it down a bit now: - If I unplug and reconnect the fuel lines and install fresh spark plugs, the car starts right up and runs perfectly. Took it around the block with no issues - As soon as I shut it off and try to restart, it won't start again - Fuel pressure while cranking is steady around 40 psi, injectors have good spray, return line is clear, and the FPR vacuum is working. It just seems like it's getting flooded after the first start I unplugged coolant sensors to see if its related to ECU flooding but that didnt make a difference. Im thinking its related to this because this issue only started happening after fixing coolant leaks and replacing the bottom part of the stock manifolds coolant pipe. My mechanic took off the inlet to get to get to do these repairs. My mechanics actually just an old mate who's retired now so ill be taking it to a different mechanic who i know has exp with RBs to see if they find anything. If you have any ideas please send em lll give it a try. Ive tried other things like swapping the injectors, fuel rail, different fuel pressure regs, different ignitor, spark plugs, comp test and MAF but the same issue persists.
    • My return flow is custom and puts the return behind the reo, instead of at the bottom. All my core is in the air flow, rather than losing some of it up behind the reo. I realise that the core really acts more as a spiky heatsink than as a constant rate heat exchanger, and that therefore size is important.... but mine fits everything I needed and wanted without having to cut anything, and that's worth something too. And there won't be a hot patch of core up behind the reo after every hit, releasing heat back into the intake air.
    • There is a really fun solution to this problem, buy a Haltech (or ECU of your choice) and put the MAF in the bin.  I'm assuming your going to want more power in future, so you'll need to get the ECU at some stage. I'd put the new MAF money towards the new ECU. 
×
×
  • Create New...