Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

there is something about 4 turbos & 16 cylinders :)

Just strap 4x Evos together. Cheaper and more powerful.

Plus it's 16-wheel drive. No cheese eating surrender monkey can do that with a VW :)

I think one of the problems is Ni that the P1 cars often end up racking up 50,000km's in 6 months and they are usually HARD km's - so I guess many of these classics just aren't up to that kind of abuse. They probably need something new they can buy and belt around for a few months and then flog off (hence the high car turn over).

Snowy gets 10 out of 10.

Being new (or near new), all our cars are covered by warranty and 24hr roadside assist. Something we NEED to have for 'just in case'.

Some of the other clubs around the world run both classic classics and modern classics - but it's not something we will do any time soon.

That said - Mustang wise, we can look at the new GT-500 Shelbys

Sam - we asked members if they wanted a 599 or LP640, and they chose the Ferrari.

That's not to say we wont get one though - just not right now.

They chose the 599 over the LP640...oh noes....although I guess the average age of most of the members answers the big why question :(

yes of course...

New GT500s are pretty dam hot too tho... same with the new camaro (when its released) and challenger SRT8 but im assuming it wont be viable as there isnt a RHD conversion available

my brother in law has a mighty boy ute if u wanna buy it for P1 l337ness... its pretty sick... red with a thick black stripe through the middle (side on not like racing stripes), polished beetle wheel caps with red steelies and whitewall tyres! Wont have to worry too much about petrol either it only uses about $15 worth for 2 weeks and seeing as the budget is only $500k im sure we can drop the price down for you james to around the $480 mark... mates rates

Interesting that you blokes all picked hot sport cars for the top 10.

I'd have thrown in a Mercedes-Benz ML63 AMG, a Maserati GranTurismo and maybe even a BMW X6 as a low points consuming weekday runaround.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • 4 to 5 is fine. It will be slow, but that's better than blowing turbos. I don't have a PS pump idle up solenoid on my car, because... I think when we put the Neo in we retained my R32 lines. But.... From inspecton of the R34 vacuum hose diagram, you can see that the solenoid needs to be connected to the turbo inlet as source of clean air) and the plenum (as source of vacuum - which is the place for the air to flow to to cause the idle to increase). So 3 to 1 is VERY WRONG. 3 should go to either the turbo inlet, or the plenum. Follow the other hose from the PS solenoid and if it goes to the plenum, then your 3 goes to 2 2 would also serve as a bleed port for a boost solenoid.
    • Pull them out and pull more apart. You can't do shit with them still bolted to the floor of the car.
    • Yes it is. ZD1 is on the other side of the board. Where ZD1 is marked is clearly opposite a 2 pin device. Our 3 pin device here is not a ZD.
    • Alright, a little update on this... I called Fulcrum, who used to be the distributor in Australia. No Bueno, they don't service them anymore.  Called shock works, who don't service them but offered to dyno the shocks for performance, and suggested DNA in Sydney might service them.  Called DNA, who also do not service them and basically said they try to steer customers away from tein for this exact reason these days- there is just no support for them anymore apparently.  Both SW and DNA said they are a not necessarily a bad product, but they just don't service the brand or know anyone who does service the brand anymore.  So... I could keep calling around but at this point I think I'll probably just spring for the shockworks product, unless anyone here knows anything.  Cheers 🍻 
    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
×
×
  • Create New...