Jump to content
SAU Community

10sec passes!!! Ice Performance Cars shine again.


Recommended Posts

Well, well, well.

The Sunday that was!!

As Wardest posted earlier, my GTR now has run multiple 10 sec passes on street tyres!!

The best of these times was a 10.47@133mph but managed a best mph of 137 for the day which we are quite happy with. All runs were consistantly in the mid to high 130s which means that we are getting almost all we can out of the car. I ran the stock GTR suspension as the Tiens were too stiff the last time we went out.

The GTR had about 10 runs of which the times of note were:

[email protected] with 1.69 60'

[email protected] with 1.65 60'

[email protected] with 1.69 60'

[email protected] with 1.69 60'

[email protected] with 1.89 60'

http://www.yatzka.com/fajuly/hjuly01.jpg

http://www.yatzka.com/fajuly/hjuly02.jpg

http://www.yatzka.com/fajuly/hjuly03.jpg

http://www.yatzka.com/fajuly/hjuly04.jpg

http://www.yatzka.com/fajuly/hjuly05.jpg

http://www.yatzka.com/fajuly/hjuly06.jpg

http://www.yatzka.com/fajuly/hjuly07.jpg

http://www.yatzka.com/fajuly/hjuly08.jpg

http://www.yatzka.com/fajuly/hjuly09.jpg

Congratualtions to Nigel's blue twin TD06 powered Supra which ran a best of 10.91@129mph. Throughout the day, the mph were always in then 129s but never quite made it to the 130mph mark :) This will be fixed very shortly :(

http://www.yatzka.com/fajuly/hjuly11.jpg

http://www.yatzka.com/fajuly/hjuly13.jpg

http://www.yatzka.com/fajuly/hjuly14.jpg

http://www.yatzka.com/fajuly/hjuly16.jpg

http://www.yatzka.com/fajuly/hjuly17.jpg

http://www.yatzka.com/fajuly/hjuly19.jpg

http://www.yatzka.com/fajuly/hjuly21.jpg

The TURBOWORX Supra was also out there (talk bout irony)....

I think the best it pulled on full slicks was 12s at 130mph which although the speed was good, couldn't hook up for some reason. Ah well, maybe another time....

http://www.yatzka.com/fajuly/hjuly20.jpg

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

hehehe wardest i wouldnt have been able to hold it in if i knew too.. thats an awesome job both dave and nigel!

7000 already? sheesh and i stopped spamming aaaaaaaaaaaages ago.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...