Jump to content
SAU Community

Recommended Posts

There is an article in the latest HPI magazine about getting 11s in your skyline...it is claimed there that around 220rwkw or slightly more is all you need for a 11 sec pass...don't quote me on that though...but whats said in that article carries alot of truth...the rest of the car's setup is just as important...so aim for about that much power or slightly more and concentrate on other areas...and don't forget driver skill too...

Link to comment
https://www.sau.com.au/forums/topic/209779-turbo-for-time/#findComment-3713318
Share on other sites

As stated in HPI No90 10 ways to an 11 second 1/4 time R33 GTST.

Stock coil overs, stock turbo, stock injectors, rising rate fuel pressure reg, a well tuned aftermarket EMS, fmic, 3-4" free flowing exhaust split dump, 1 bar boost, 15" Drag radial tyres inflated to 20 psi, strong single plate clutch, 1/4 tank of fuel.

Also remove any excess weight from your car like spare tyre, passenger seats, etc.

Sounds like a good recipe for 220 rwkw.

To get into the 11 second mark with these mods would also need some drag racing experience i would think. As also stated in the mag.

Link to comment
https://www.sau.com.au/forums/topic/209779-turbo-for-time/#findComment-3714806
Share on other sites

Yeh the latest HPi has mainly how to get your skylines doing 11's! pretty good read. I was reading it all night. Geting slicks for your ride would be good to!!

Slicks..why bother, why would you go to a drag stip, run a 12, bolt your street rims back and only have a 13 second car all of the time. Although ' street ' rubber is a harder way of getting the times, atleast you can drive away from the drag strip after you've done a 12 second pass in a 12 second car. Don't always believe what you read in HPI too :domokun:

Link to comment
https://www.sau.com.au/forums/topic/209779-turbo-for-time/#findComment-3714821
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
×
×
  • Create New...