Jump to content
SAU Community

Recommended Posts

When accelerating in second gear form 60 to 100 sometimes theres a slight flat spot at the 80Km mark.

I have a 93 R33 manual Exhaust blow off valve.

I thought this may becauce of the exhaust and/or blow off valve

but I noticed this on another skyline I test drove a dead stock 95 r33 man.

I have only owned the car a couple of months and I am new to turbo cars. Is this normal? or do I have a fault?

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/
Share on other sites

Probably just the way the stock fuel maps are setup in the ECU - if you wish to reduce it you will need a method by which you can adjust the air/fuel mixtures at particular revs... most use a S-AFC, piggy back ECU, or aftermarket ECU to do this. Hope that helps..

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-448885
Share on other sites

If you get a boost controller you will probably need some sort of fuel cut defender or you will get an even bigger flat spot. Do any electronic boost controllers have these? My Profec B doesn't, the car came with a HKS fuel cut defender as well and it works perfectly.

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-456543
Share on other sites

Guest Robo's

Mines got a bit of a flat spot too, sort of surges abit, its running way too rich as it backfires sometimes too. But sometimes it will pull all the way, but when it gets warmer (motor, airflow) it gets more consistant. First im going to try a cold air intake, as when i pop the bonnet and put my hand over the pod, it is very hot.

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-467813
Share on other sites

Yepp - this is very typical from the R33's.

You should see my dyno run !! Big dip in power when the ECU pulls timing and dumps fuel at about 4-5000 rpm :)

The S-AFC will help. It fools the ECU and shows the ECU a reduced air flow rate, therefore the ECU doesn't pull as much timing blah blah blah.

J

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-467849
Share on other sites

has happened with my rb30 as well hehehe

what it sounds like is mainly ur afm

im not too sure about the right setting for a rb25 , but with a rb30 , the air flow meter , needs to read a set ohmage of 382ohms , this measurement is taken from the 2 outer most pins on the afm , where the loom plug connects to it.

if its out it dummys info to the computer which is not correct and makes it run rich/lean etc , causes flatspots and hesitation etc etc etc.

also things like malpassi rising rate regulators can do it too , as boost hits , the fuel pressure rate rises at whatever rate the reg is (1.5:1) etc and that sudden fuel dump doesnt immediately get burnt , bit of a dull spot.

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-468863
Share on other sites

  • 3 weeks later...

Robo's Yours sounds exactly the same as mine.

Have you tried a smaller gap on your plugs yet?

Unfortunatly I live out in the country and I am the only one in town with a r33 gtst so I cant swap the air flow meter with someone.

Anyone else had this problem and solved it (cant afford SAFC).

Link to comment
https://www.sau.com.au/forums/topic/21267-flat-spot/#findComment-500311
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...