Jump to content
SAU Community

Recommended Posts

this can be continued in the calendar thread, although ive sent hostile a PM. I do appologise again that you never got last years. I make no money out of these, so its out of my pocket to give the free ones of the 2010 calender to those that missed out, but im more than happy to do that, and I stand by my word.

BACK TO THE PHOTOS!! :)

chad, what polish/wax do you use? whatever it is, keep using it!

Funny thing is i really don't look after the paint on it, I rarely wash it and when i do wash it I use one of those brushes at the car wash. The day I took it to the EHP show i just washed it and drove down there then used some Meguiar's waterless spray detailer and it came up a treat :D

Oh! and the bonnet was re-sprayed not long ago so its still nice and shiny.

Edited by DSTROY
Funny thing is i really don't look after the paint on it, I rarely wash it and when i do wash it I use one of those brushes at the car wash. The day I took it to the EHP show i just washed it and drove down there then used some Meguiar's waterless spray detailer and it came up a treat :(

Oh! and the bonnet was re-sprayed not long ago so its still nice and shiny.

Chad

the photo at EXHP was photo enhanced to bring out the shine a bit. Megs Stuff works a treat either way. (or Mothers)

never use a car wash brush, its loaded with sandy bits and filth.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...