Jump to content
SAU Community

Recommended Posts

Ok, my mechanic says my piggy back is a pain so im after a new engine mangement system for my R33 GTS-T, How about some opinions on what people think is good and what isnt.

Im looking for something that will be able to accept future mods and give me good engine protection.

I also have all work done by a mechanic(yes im lazy).

Also im looking around for good mechanics in the liverpool area of NSW as this is my first vehicle that needs a specialist to service and tune.(ive only owned V8s and Motorbikes in the past).

The motor internals will be standard and i will only be adding bolt ons.

Thanks for any help.

MLR

PS, I wish i had a car with the scarry fast feeling i get with my old 1100 GIXXER (pity it corners like a wet spounge). :D

Link to comment
https://www.sau.com.au/forums/topic/224639-engine-management/
Share on other sites

need to know how you want the car to perform...

if you're only after 200rwkw in an rb25 you could get away with a safc...

250 you could do an emanage

more i'd be going pfc / haltech

As far as I am aware, you cannot retune R33 ECUs.

What about a Wolf V500 - cost is around $2500, installed and tuned. "GHOSTT' - R33, lots of go-fast goodies - pushes 450+ kw at the rear treads. And Australian designed and manufactured.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
    • Yeah, I don't believe the M35 uses a deadhead system.
    • Have you done your thinking backwards? 3 bar, 43.5 psi pressure drop being the presumed specification for an injector, means you need 3 bar upstream when they are firing into atmospheric pressure, and more upstream pressure than that when on boost (you add your boost to your rail pressure to maintain 3 bar across the injector) and you need..... less pressure upstream when you have vacuum in the manifold. So, presuming that you're idling at -10 psi, then you only need ~23 psi in the rail. I realise that I did not need to say all of that to you specifically Matt, once you'd realised your mistake. It's mostly there for complete clarity for others.
    • Have you reached out to the guys at Spool Imports? They are a Ross dealer, I can imagine they would have the rings just sitting on the shelf (I could be wrong).  
×
×
  • Create New...