Jump to content
SAU Community

32 Gtr Running Like A Wheel Barrow

den001

By den001,
in Engines & Forced Induction

 Share

Recommended Posts

den001 Proficient

den001

Posted
Posted

i have a 32 gtr,

now on wendsday i took it to eastern creek and posted a top time of 11.7 at 115mph, with only a exhaust and 13psi boost, stock turbos, stock ecu

i was wrapt....

before this i could always noitce somthing like a choking feeling while the engine was reving out, and you could notice the torque loss, not massivly, but abit......

this was more only during the day time, during night it would run mad.... i put that down to intake temps

now, since i ran that time, the next day i went and put some cam gears on and set them to 2 deg advance on intake and 5 deg retard exhaust, ran the car, perfect, absolute animal compared to the 11.7 pass.... i couldn't believe it, this test was also at night, drove home, woke up im morning, and took for another drive, same as before, feeling lazy and choked up during the day, night came, abit better....

now tonight, i have noticed a big amount of power loss, and a shit load more laziness, the exhaust note has changed, sounds choked up, the engine builds boost good as i watch the gauge but its like the motor doesn't like the positive pressure its being given.... and lost throttle response...

i always put good fuel in aswell

also under load like at 2500rpm in 5th, ill put the throttle flat, and it will build boost probably up until 3000rpm and then the bov's start making their noises with my foot still to the floor...

now i think that this may be something to do with the computer, but im still unsure but wtf is the story with the bov's going off while still under load????

any1 with similar issues?? or theory's

any and all help is appreciated

cheers

denis

Link to comment
https://www.sau.com.au/forums/topic/226038-32-gtr-running-like-a-wheel-barrow/
Share on other sites
Rowdyr32 Mentor

Rowdyr32

Posted
Posted

Maybe you stock has picked up knock and is running the other map. Try disconnecting you battery for a while and put on the interior light for 2 minutes then reconnect everything. Possible??? Also try the diagnostic on the ecu?

The factory ecu can by what I've been told reterd timing if it sensors knock something a pfc cannot.

swanny180 Proficient

swanny180

Posted
Posted

Make sure your cat converter hasn't melted to pieces and become an exhaust restriction.

Only takes a minute or two to pull it out and have a look, and wont be difficult to replace if it is your problem.

den001 Proficient

den001

Posted
  • Author
Posted

ok, the cat is gutted aniways,

now i resset the timing back to standard and it seems to have more torque again, but that choking issue is still there, after about a 20 min drive when everyting warms up good, the choking issue rises again, could it be the o2 sensors???

i know that the cat o2 sensor is not there and the wire has been cut..... and they are definatly not touching....

yes 11.7 with only thoes mods...

pitty it wouldnt do a 18.7 now, jokes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...