Jump to content
SAU Community

Who Tuned Your Car?

sam.murray

By sam.murray,
in Tasmania

 Share

Recommended Posts

sam.murray Community Regular

sam.murray

Posted
Posted (edited)

Hey guys,

I dont know if this post has been done before but basically I want to know who tuned your car.

Please include:

MODS

Power Figure

Price

ECU (PFC, Microtech ect)

Service - Was it good or bad?

Please also PM if you have any bad info on tunners or people I shouldn't use.

I want to book my car in to get tuned. Its an RB25DET with Power fc, and bolt on mods.

Kind regards

Sam Murray

P.S if this a repost some on can slap me and point me to the original post that would be awsome! I had a look but couldn't find it for Tas.

Edited by sam.murray
Link to comment
https://www.sau.com.au/forums/topic/228041-who-tuned-your-car/
Share on other sites
Wogboy Mentor

Wogboy

Posted
Posted

Dr Drift, R31 RB25det

MODS; TD06, injectors, exhaust, CAI, fuel pump.

Power Figure; 240 rwkw @ 13 psi, 255 rwkw @ 15.5 psi, 265 rwkw @ 19 psi

Price; $650.00

ECU; Factory Nissan R32 GTS-T

Service; Fantastic!!

Pro Automotive, R34 GT-T

MODS; FMIC, injectors, exhaust, CAI, fuel pump.

Power Figure; 210 rwkw @ 13 psi

Price; $300.00

ECU; Power FC

Service; Excellent!

sav man Grand Master

sav man

Posted
Posted

Boost Automotive, R32 GT-R

MODS: HKS GT2530's, intercooler, exhaust.

Power Figure: 311rwkw @ 1.1bar

Price: $850 from mem (that included Plugs, Oil and wheel bearings)

ECU: Power FC

Service: Excellent

Boost Automotive, R33 GT-R N1

MODS: exhaust.

Power Figure: 323rwkw @ 1.3bar

Price: can't remember

ECU: Power FC

Service: Excellent

t01-100 Mentor

t01-100

Posted
Posted

Andrew at Pro Automotive is very good and cannot recommend enough. He will provide a safe tune that you do not need to worry about.

Pro Automotive, R32 GT-R VS-II (2005)

MODS: Exhaust, N1 Turbos, Nismo fuel reg, K&N panel filter, 95RON PULP

Power Figure: 255rwkw @ 16psi (Dyno Logic)

ECU: Mines VX-Rom

Service: Excellent

Car Performance: Consistant fifth position on most stages at Rallye Burnie that year

Pro Automotive, R32 GTS-t (2004)

MODS: Exhaust, FMIC, 98RON PULP

Power Figure: 177rwkw @ 17psi (Dyno Logic)

ECU: Unichip

Service: Excellent

Car performance: low 62s at Symmons

Howell Automotive, S14 (2003)

MODS: Exhaust, HKS pod filter, fuel reg, 95RON PULP

Power Figure: 180rwkw @ 17psi (Dyno Dynamics), but struggled to show more than 150 on Pro Automotive Dyno Logic dyno

ECU: Unichip

Service: Excellent

Car performance: low 63s at Basky

grandmasterb Grand Master

grandmasterb

Posted
Posted

R32 GTS-t - RB20

MODS: TD-06 20g l2 kit with 10cm rear, 3" dump, FMIC, stock cat back/injectors/afm, 95RON

Power Figure: 205rwk @ 14psi

Price: $650

ECU: remapped Central 20

Service: Couldn't complain at the time

Im currently looking at tuning option for old girl again with the new set up and after talking with Kuc he was not only extremely helpful but also came straight out and said that i should have a look around at other tuners as he didn't feel he could get the best out of my set up.

Even after that he has still taken the time to answer questions that i've had so its a big :) for me to Pro Automotive

I had my 1600 (FJ20) tuned by Kuc and the stanza (Z18) was tuned by Griffo using Kuc's dyno :)

guesty Proficient

guesty

Posted
Posted

Boost Automotive R33 RB25det

MODS, 3in turbo back exhaust, front mount, fuel reg, fuel pump, Greddy plenum, pod,

Power Figure 214km @ 10psi

Price bit over $500

ECU Power FC

Service - as posted in a thread last year, was not happy with the service at all, quoted $300 to adjust the map as it already had been tuned. they went ahead and put iridium plugs in it and removed some of the silicon hoses and put heather hose there instead.

have sent several cars down to Kutsie at pro automotive and am very happy withthe results. he's very good with comunication and will talk to u about what you want to use the car for etc.

woolls Experienced

woolls

Posted
Posted (edited)

Pro Automotive;

MODS; Fmic, Hks pro s 2835 turbo, injectors, cams, plenum, fuel pump

Power Figure; 228 rwkw @ 15 psi,

Price; carn't remember

ECU; power fc

Service; ok. I would never bag him out, there is plenty of people out there who have got great results.I just didn't get the result I wanted.

Dr Drift

MODS; Fmic, Hks pro s 2835 turbo, injectors, cams, plenum, fuel pump

Power Figure; 260 rwkw @ 15 psi

Price; $150.00

ECU; Power FC

Service; Sam only had mine on the dyno for an hour, I didn't want to go above 260rwkw as i don't want to risk the standard bottom end. very happy with his service.

Edited by woolls
madaz R33 Proficient

madaz R33

Posted
Posted

Boost Automotive;

MODS; Fmic, VG30turbo, injectors, fuel pump, A/MDump pipe, Elec boost cont, Pwr Fc

Power Figure; 248 rwkw @ 15 psi,

Price; think it was about $430

ECU; power fc

Service; ummm, not bagging, but lacks costomer service skills at times.

WHITER33GTS-T Veteran

WHITER33GTS-T

Posted
Posted

Boost Automotive;

MODS; Fmic, twin T3/T4 turbos, 1000cc injectors, cams, plenum

Power Figure; 399 rwkw @ 17 psi,

Price; Think it was about $400

ECU; Haltech E11v2

Service; great.

This was my old RB25 and will take the new setup to him also. That is all the same goodies on a 25/30

DJRIFT Veteran

DJRIFT

Posted
Posted

Well theres only a few choices in tassy realy. and if you read every thing on the net they all have strong positives and negatives.

i recently took my car to boost

MODS: FMIC, gtr injectors, r34 turbo, good dump pipe and 3" straight through exhaust. runing on and rb25de

power: 194rwkw on 10psi but detuned for a slipping clutch

Price: $420 including iridiums

ECU: power FC

Service: i was happy with the service but and there is always a but it cost nearly doubble what i was advised (not quoted) would have been close bar the iridums

i was very happy with the feed back about my motor and alike. ive been told this isnt a strong point with boost but i was happy.

i am unsure if i will try some where elce next time.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • ARB26
      S1 Autech 260RS Wiring Diagrams

      By ARB26 · Posted

      I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...