Jump to content
SAU Community

Recommended Posts

it's getting close now, just had my leave approved, and Damo and I will spent the long weekend doing recce.

Had my car out on the track week before last, need to get some time as baskerville to set the suspension up properly though.

who's GC8 you flogging?

Edited by sav man

I'm a fan of not getting arrested. Hence the racetrack, esp this close to Targa the coppas will be on the lookout for Targa recce.

Yeah goes well, very happy with it. I'm surprised how easy it is to drive, the lack of tourqe means it won't spin the wheels unless you clutch it. Got it into the 62's at Symmons, i've put some more boost and timing into it since then. E85 is on the way too.

Great news Ben, how does it go/ Do you like it?

The GC8 is one of Rallyschool's.

What is the go Timmeh?..... engine cactus?

Guru at Fitzgerald's says engine is fine, just head gasket which may have happened when split radiator hose way back at High Country, just wasn't showing up until engine was heat soaked... Find out next weekend when it gets a thrashing.

Cross fingers/Touch wood/pat head/spin around 3 times/throw salt over shoulders.

Otherwise ill let everyone know where the best bonfire is going to happen post Targa!

Well I completed my final shakedown on the weekend and can say this new car is finally pretty good. We found last week a cracked turbo intake pipe which obviously hasn't been helping! No idea how long that had been there because it hadn't been on a dyno since it was first built. We also have finally got the handling balance right so lets bring on Targa!

Less than a month to go!

:)

Good news Snowdaddy! Have we got a confirmed 'crew' yet??

I'm a fan of not getting arrested. Hence the racetrack, esp this close to Targa the coppas will be on the lookout for Targa recce.

Yeah goes well, very happy with it. I'm surprised how easy it is to drive, the lack of tourqe means it won't spin the wheels unless you clutch it. Got it into the 62's at Symmons, i've put some more boost and timing into it since then. E85 is on the way too.

What cops? ours are all in court babysitting criminals. If your smart and recce in a silver falcon, people think you are the cops (as was the case twice during Rally Tas recce!)

i can second that bens new car is easy to drive. its a surprise to us both we havent discovered more faults with it as we are just 2 noobs building a race car from scratch. a few more bits to finish off yet thoe.

if i had of driven at symonds the other weekend i could have nudged a 60. its that easy to drive.

oh and the brakes are unreal for non asisted items.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...