Jump to content
SAU Community

my car is sooo damn quick

34GTt

By 34GTt,
in Western Australia

 Share

Recommended Posts

Jase Collaborator

Jase

Posted
Posted

hehe :D

mebbe the guy (or gal) wasn't racing anyway

in a GTR, you don't need to race too many folks

I always laugh when those little Hyundai drivers want to give you a drag

gee I laugh so hard when they do that

the little flashing lights in the car do something to their brain I spose :)

OptiC Enthusiast

OptiC

Posted
Posted

Really why didn't you just give that car to some one that could drive ? i'm sure there are a lot of skyline owners that can drive down a VERRY smooth VERRY wide strech of road and have more sense than to drive the car into a pole it takes a whole .000000002 of a second to realise thats not a good idea :|

waste of a good car if u ask me

Guest R33GTS25T

Guest R33GTS25T

Posted
Posted

Sorry but not all us "P" platers are responsible for the rise in insurance premiums its the older folk who have their mid life crisis' and decide to go and buy a perfomance car thinking they can drive it no probs... Then you see them in a wall. Just cause were new dont mean were not talented... :D

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Nissan fuga 450gt android screen

      By GTSBoy · Posted

      So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
    • The king 2.0
      Nissan fuga 450gt android screen

      By The king 2.0 · Posted

      Yes then it will turn on but I want the car features to work  
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • pacman_1219
      Blue/grey smoke after idle

      By pacman_1219 · Posted

      Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • GTSBoy
      Nissan fuga 450gt android screen

      By GTSBoy · Posted

      What about if you just give it direct 12v and earth?
×
×
  • Create New...