Jump to content
SAU Community

Recommended Posts

ported head matched manifolds

jun guilds stano vavles

stock cams

stock cam gears and springs

baffled sump oil restrictors in the block cam cover plates

jun collar and oil pump

acl race bears mains and big ends

rev rods

cp pistions

1.3mm metal head gaskit

metal inlet manifold gaskits

pfc

stock cooler

stock inj stock fuel pump

stock air flow meters

stock dump pipes

front pipes 3 inch cat 3inch exhuast and cannon

stock turbos

os giken twin plate clutch

eboost 2 set to 13psi

262rwkw!!! 351hp

i was very surprised! can not thank anth enough at turbotechics more responce every were! and better on fuel! :D

thoughts ideas?

inj were 85% maxed

anth said to go inj and a bigger fuel pump next...

Link to comment
https://www.sau.com.au/forums/topic/231030-gtr-tuned-yesterday/
Share on other sites

not bad for old turbos! but yeah why retain so much stock gear? id be presuming you must have been quite happy with it in stock form, and just wanted a bit more from it.

what is the stock 32gtr gear, fuel system, and turbos good for power wise? The 34's are good for almost 300rwkw with just some basic breathing mods and an fc arent they?

Why are you risking a built motor by using stock turbos?

You obviously like to gamble :D

You need turbos before anything else. Fuel pump/Injectors co-incide with larger turbos. They are more than fine for the stockers... which again i stress... get rid of them

Im getting 212rwk on 9psi and little timing on a conservative run in tune, my turbos are stock size but have steel wheels in them. Built engine to

Other power mods are HKS dumps, apexi front's, 5zigen catback, stock cat, PFC, splitfires, hks duel power and arc induction box. So realyas far as power goes, exhaust, intake and very conservative tune...

Love the response :ermm:

Edited by bnr#@
Im getting 212rwk on 9psi and little timing on a conservative run in tune, my turbos are stock size but have steel wheels in them. Built engine to

Other power mods are HKS dumps, apexi front's, 5zigen catback, stock cat, PFC, splitfires, hks duel power and arc induction box. So realyas far as power goes, exhaust, intake and very conservative tune...

Love the response :ermm:

Your going to love MOAR boost after your run in. whats the plans for boost when done?

Your going to love MOAR boost after your run in. whats the plans for boost when done?

Plan is 16psi, the cam gears are yet to be adjusted to and a good tune to be done, should be fun :thumbsup:

Doing brakes first and a few suspension touch ups though so about a month away

ran out of money for turbos....

i like the responce of the stock turbos just wanted to see how much it made with the power fc and no dumps or cam gears first...

and i have seem to made 10kw more than others with cam gears dumps...and on only 13psi not 15 16psi.....

would be interesting i think with cam gears dumps and say 15psi but i dont wont to push the stock turbos....

ill run it at eastern creek next and see how i go...

would be very happy as it is, if i get a 11?

also what did it cost to put the steel wheels in the stock turbos? will be interesting to see what you make on them!

i think ill go spit fire coils next.... inj and a fuel pump...then decide on turbos or a single and air flows metres and a intercooler and make some big power :thumbsup:

Maybe 10rwkw more/1 less psi is dyno variance more than anything else than a solid difference :thumbsup:

A GTR driven hard (on stock turbos) can do mid 11's, it's been done before. However most likely low 12's for you unless you've had a good few outings before and can launch it right etc etc

Personally i wouldnt steel wheel turbos, with the R34 N1's, -7's, GT-SS being the price they are today... better off to just go down that road IMO rather than fixing up the stockers with steel wheels. And then you'll get a little more peak power (well, about 40rwkw or so) with pretty much the same response too :ermm:

i think i have the take off down patt now around 6000rpm seems to work well :thumbsup:

i was looking at gtss befor but now that it made 260kw is it worth it for 40kw? would be interesting to go in a gtr with them to see....

if i go cam gears would i see 10kw more?

i think i have the take off down patt now around 6000rpm seems to work well :P

i was looking at gtss befor but now that it made 260kw is it worth it for 40kw? would be interesting to go in a gtr with them to see....

if i go cam gears would i see 10kw more?

ye as stated, cam gears is more mid-range repsonse than anything else.

As for 40kw? Your talking more like 70kw with GT-SS/N1/-7 :P

310-330rwkw is around about the end result from most peoples setups over 20psi

i think i have the take off down patt now around 6000rpm seems to work well :D

i was looking at gtss befor but now that it made 260kw is it worth it for 40kw? would be interesting to go in a gtr with them to see....

if i go cam gears would i see 10kw more?

As Nismoid said even more then 40kw though it is also more reliable...

You don't have to worry about the ceramic wheels at all.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...