Jump to content
SAU Community

Recommended Posts

  • Replies 77
  • Created
  • Last Reply

Top Posters In This Topic

Very tidy Scott, but what's the red switch for if you don't mind my asking.

for my NOS bottles...... hahahaha nah just kidding..... its for my boost controller. Have low set on about 8psi and high on 12-13psi... love that switch deffinately comes in handy =]

Those pics are pretty old.. I tooks a few more the other night but only difference is shortened gear knob and Nismo badge

Skyline-13.jpg

Skyline-14.jpg

hey mates..just found this guy from south east melbourne selling really nice interior for r33 and r32, friendly and patient guy. cost me around $120 but havent fitted in yet, as i'm busy for the x'mas. Anyway if anyone is interested, feel free to drop him an email at [email protected] "ekkoperformance"..cheers

post-58226-1229856804_thumb.jpg

the whole interior cost you $120? what does the package comes with

Whole set comes with:

2 x Front door trims, 1 passenger 1 driver

2 x Rear arm rest trims, 1 passenger 1 driver

1 x Centre console lid

1 x Glove box trim

1 x Set of instructions on how to install :P

My interior

IMGP1788.jpg

9fd0.jpg

Just thought it should be known that this R33 has a FULL Cusco roll cage (from what I can see) perfectly integrated to the standard trim... this is really beautiful in it's own right... how much police trouble have you had from this?! :rofl:

PSI Parts also noticed this, as I would expect :P

shits all over my painted interior n shit

  • 1 month later...
Just thought it should be known that this R33 has a FULL Cusco roll cage (from what I can see) perfectly integrated to the standard trim... this is really beautiful in it's own right... how much police trouble have you had from this?! :D

PSI Parts also noticed this, as I would expect :)

Sure did :banana:

Just going back to the cage, would this be CAMS approved? I seem to remember CAMS only allows two bends in each corner bar for structural reasons? (Yes I can't be bothered looking at my CAMS manual)

Yep, cheaper rego too :P

So am I right in saying you can rip your rear seats out and all you have to do is re-register your car as a 2 seater.

Or is there more involved..ie; RTA inspections, etc.

I wanna rip out everything I can!

So am I right in saying you can rip your rear seats out and all you have to do is re-register your car as a 2 seater.

Or is there more involved..ie; RTA inspections, etc.

I wanna rip out everything I can!

If you remove the rear seats and register as a 2 seater, the rear seat belts need to be removed as well as far as I know

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...