Jump to content
SAU Community

Recommended Posts

Yeh i went through Extensive Wheel service, its 307 South Road Mile end. PH: 83525777.

I went there about 12 months ago....due to a bit of immature driving, smacked up all 4 rims pretty badly. They do a pretty damn good job tho i must say but it didnt come cheap, it cost me $165 per rim so it was a fairly costly experince. It cost more because the way they were bent and the fact they had deep dish, so it does depend on what rims u have on as well. Hope this gives u a better idea.

cheers

Adelaide Wheel and Rim quoted me heaps to do a simple rim job for my race bike a year ago, then turned around a week later when I checked up on it and said it couldn't be repaired. So I walked across the road to Extensive Wheel Service who did the job cheaper than AWRs quote and got it straight :/

The guy who runs EWS use to work for AWR and left due to poor service. The guy at EWS is more than happy to beat AWRs quotes.

if ur out north try ringing comercial metal polishing they have a guy that used to work at one of the 2 joints mentioned above but left due to management and has just joined up with gino there best of both worlds

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Waaay ahead of ya....(evil laugh!!) Will show the fitment and spec details later when it isnt as rainy !
    • Thanks Dose.....    I appreciate it!!
    • I'll probably be putting the shit box back on the dyno again soon, I want to dial in the closed loop boost control properly. I'll have a camera facing the car/motor for fun too. Just note, there are essentially 3x 10AN inlets going into the catch can and 1x going back to the intake pipe. Most of the time the catch can "return" to the sump actually is the crank case breather, pushing air out.
    • I have the R3C with a Nismo slave and by no means does it behave like a stocker, it ain’t THAT bad. On take off just give a bit more throttle than you would say a coppermix and it’s fine. It will not slip though.   
    • Okay. Final round of testing done. Got a friend to hook up a fancy scanner to the car and we also ran some compression and leakdown tests, she is healthy.  The MAF was definitely the culprit. So for future reference anyone with similar issues that find this thread. I suggest the following steps, in order of affordability:   Check your spark plugs for any fouling, replace plugs if they are bad or re adjust the gaps making it narrower (0.8mm would be good). Check every coil's resistance with a multimeter. It can be done by probing the IB and G pins on the coil pack. Resistance should be around 1.4 (+/- 0.1) Ohms Check the MAF. If you have Nissan connect or a good scanner with the 14 adapter it should allow you to see the voltage on the MAF reading should be around 1.1 - 1.2V when car is idling. But if you don't, buy a new MAF from Amazon and test, then return it. (For instance, I got a Chinese one for $40 that was reporting 1.3v on idle). If you still have scanner, you can run tests on the injectors to see if they are working, just remember to unplug the fuel pump fuse/relay and have no pressure on the line. Then listen for the noises that the injectors make. Clean/replace injectors as needed. Once you find the issue and fix, order thousands of dollars worth of OEM parts to refresh unrelated things (Optional)   PS: Thanks to the absolute legends of this forum for the responses and help to someone that went a bit over their head. (me)
×
×
  • Create New...