Jump to content
SAU Community

Recommended Posts

Item: 1989 Nissan Silvia

Location: Toowoomba, Qld

Item Condition: Good

Reason for Selling: New house settles in 2 weeks and this car can't get in my driveway!

Price and Payment Conditions: $10,400 for the lot, $9800 without spares or Work rims

May swap for Subaru Outback, Forester or similar, or single cab ute (pref 2.7L Hilux) plus cash my way.

Extra Info:

ENGINE

-Rebuilt SR20DET Engine (Head rebuilt ~5k ago, bottom end ~25k ago)

-Currently 180rwkw@15psi, was previously making over 220rwkw@21psi

-Ran 1.03 QR Sprint 2nd time out, capable of much quicker times

-SR20de Inlet Cam

-Modified combustion chamber

-Port matched inlet

-New rings/bearings

-90mm Exhaust

-Plumb back blow off valve

-Modified S15 Turbo

-S15 Injectors

-RB20AFM

-S15 ECU w/ BikiRom USB Multiboard

-600x300x75mm Front Mount Intercooler

-Turbosmart Manual Boost controller

-40mm aluminium radiator

-S15 Jap Spec HID Xenon headlights internals

DRIVELINE

-5spd Manual gearbox

-2000lb Excedy full face organic clutch

-Nismo 2-way mechanical Diff

-Full 5 stud conversion

-S15 rear subframe

-BRAND NEW Adjustable Rear Upper arms

-BRAND NEW Adjustable Rear Traction arms

-Tein HR Coilovers Front/Rear

-Tein Caster Rods front

-Tein Tie Rods w/ spacer

-Tein Tie Rod Ends

-S14 front arms & Hubs

-R32 rear hubs

-R32 Aluminium 4 piston Front Brakes

-R32 Aluminium 2 piston Rear Brakes

-ADR Approved Braided Brake lines (Front & Back)

-Braided clutch line

-Alloy steering shaft spacer

INTERIOR

-Sparco PRO 2000 Bucket seat

-Omori gauges (water temp connected, oil pressure and temp not currently)

EXTERIOR

-Average paint (average roof, small amount paint missing from LH door and under RH mirror)

-Fixed sunroof (for extra headroom & no leaks)

-Newly tinted side windows

-Work VS-KF 17x8 and 17x9 rims with Pirelli 225 and 235 tyres

SPARES:

-4x Volk GTC 16x7.5 Track Rims (rough condition) fitted with Dunlop D01J Semi Slicks (few sprints left in them)

-4x Fury 17x8 rims with good 235/45/17 tyres.

-Spare fixed back bucket seat in good condition

-Alloy intake pipe with silicon joiners

-Spare adjustable rear arms

-Spare steering wheel

-4 point harness

-Rare genuine aero front bar (needs painting)

Registered until November (no RWC included in sale due to time restrictions)

For $10,400 will come with all 3 sets of rims and other spares.

For $9,800 will only come with Volk track rims

Contact Details: PM me or email [email protected]

Pictures:

neil_se20080924184847pslfile1.jpg

neil_se20080924184740pslfile1.jpg

neil_se20080924184702pslfile1.jpg

neil_se20080924184815pslfile1.jpg

neil_se20080924184757pslfile1.jpg

neil_se20080924184832pslfile1.jpg

neil_se20080924184719pslfile1.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
×
×
  • Create New...