Jump to content
SAU Community

Recommended Posts

Try some bricks and a plank of wood! works a treat.. smile.gif
i think ill pass on the bricks and wood....

lol

Buy a set from Repco - 50 buks - you will need them more then once im sure so its a worthy investment? - but im guessing since you asking to borrow your not whilling to spend the dosh - where by the plank and wood idea seems right up your ally

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4239202
Share on other sites

I have...

i) big ramps

ii) extra loooow ramps

iii) hydraulic jack

iv) jack stands

v) witches hats to surround your car

vi) yellow tape with black stripes to wrap around the witches hats

vii) hard hat and...

vii) a sign that sticks into a witch hat that says, "HARD HAT AREA"

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4239311
Share on other sites

I have noticed that Terry...

i) likes making lists

ii) applies different lists to different topics

iii) uses the same layouts

iv) has a witches hat with a sign

v) doesn't like writing full sentences

vi) has too many points for each topic :(

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4239331
Share on other sites

I thoroughly enjoy all of terrys posts - they are informative and funny at the same time :D - also quite a list of stuff you have there terry - i went to the site but for the life of me i cant find anything on it - and i have been on it more then once trying to find stuff befor!!

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4240993
Share on other sites

I have noticed that Terry...

i) likes making lists

ii) applies different lists to different topics

iii) uses the same layouts

iv) has a witches hat with a sign

v) doesn't like writing full sentences

vi) has too many points for each topic :(

Lol so true but his posts are funny and helpful :D

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4241039
Share on other sites

all sweet...changed cat back whilst on the ground....take that 100 ramps....

thanks anyway guys.....wasnt too hard...

oh and rb with just 3" dump pipe sounds sweet....well actually very nasty...sounds like a dragster...

That's the spirit!!!

Link to comment
https://www.sau.com.au/forums/topic/243218-car-ramps/#findComment-4241520
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
    • What air filter are you running? Is it a panel filter in the stock air box, or a pod filter? Is the air filter the type that is oiled?   If you unplug the IACV, what rpm does the engine idle at?
    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
    • I've looked up the parts number (41011AL501). It's around $700 OEM. Usually our Infiniti G35 here in Canada have interchangeable parts with my Stagea but the parts number are not the same. I have looked around and it seems the JDM 2005 V35 Skyline (which is the same as our G35) has the same caliper but I cannot confirm. And I can't find a repair kit. The inner brake pads drags on the rotor, seems to be rusty piston. Thanks for the info by the way
×
×
  • Create New...