Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

hey questions, can they send you all the way to regency of they defect you way out in country SA somewhere? would seem a bit stupid having to travel all the way to adelaide just to clear a defect? they would just send you to the closest cop shop in this situation?

Yeah gotta cop ride height on the chin, there's no way I can say it doesn't "look" that low when hes gotten the tape measure out already...

I found the PDF that contains the eyebrow heights...it doesn't have my car on there! 89 GTR, they've got:

GT'R June 91 onwards 375/355 (WTF? 375?)

R32 Turbo Low Volume Import 91 onwards 360/360 (pretty sure this is GTSt)

Only one that matches the year would be June 88 TI/Silhouette GTS 330/325 :banana:

For those playing at home: Eyebrow heights

That PDF is way out of date.

Speak to Vehicle standards they too will tell you it has changed.

For example the R32 GTST used to be 360mm all round.

Now its 345mm front 355mm rear.

When lowering a vehicle body, either front or rear, the limiting factor is the clearance between the rubber bump

stop and the corresponding metal stop. This dimension must not be reduced by more than one third of that

specified by the manufacturer.

Transport SA has a list of acceptable suspension and eyebrow heights (the measurement from the centre of the

wheel vertically upward to the edge of the mudguard) for most passenger vehicles and can be contacted to

verify if the ride height of a vehicle is within acceptable limits.

Info_bulletin_3.pdf

Yeah gotta cop ride height on the chin, there's no way I can say it doesn't "look" that low when hes gotten the tape measure out already...

I found the PDF that contains the eyebrow heights...it doesn't have my car on there! 89 GTR, they've got:

GT'R June 91 onwards 375/355 (WTF? 375?)

R32 Turbo Low Volume Import 91 onwards 360/360 (pretty sure this is GTSt)

Only one that matches the year would be June 88 TI/Silhouette GTS 330/325 :D

For those playing at home: Eyebrow heights

haha that is soooo wrong

i just got cleared from regency not long ago

R32 GTS-t is 345 and 355

GTR is very very very close to this as i remember seeing it in the cops book but clarify with regency, BUT GO TO VEHICLE STANDARDS and check, dont ring............

Guest CleanAndSimple

Found This On Another Website. May Be Helpful As Helped Me, (Even Tho I Have To Go Back SIGH)

Just make sure u have the proper sealed battery (if its in the boot) and all ur splash guards are alright. Sigh Seems Stupid But Thats All They Cud Get From My Car LOL!.

Best Of Luck

In Cabin:

1. check every single bulb on your car is functional, including hazards

2. washer jets work and u have water in the reservoir

3. all of your seats are legal. Seatbelts ALL work. Seat slides forwards and backwards as it is meant to.

4. get subs and amps out. The less non standard stuff they notice, the better. Go in with your car stock as possible.

5. your steering wheel is stock or legal. This applies also to the boss. It cancels the indicators.

6. horn works

7. windows are all working and there’s no crack.

8. all panels etc are fixed and secure.

9. tint is legal. Make sure it’s legal. A lot of guys are failing on this. if it’s not, take it off. If you’re not sure, find out. Be sure.

10. No loose wires anywhere hanging around the place.

Sub Frame & Shell:

1. all boots on everything are in good nick. CV boots, steering boots, strut boots. Mikey didn’t get thru cos of this kind of thing.

2. no significant cracks to subframe or suspension assemblies.

3. all panels are fixed and secure. This includes little things like your wheel arch liners, grill, etc. Make sure all your panel pins are in place and doing their job.

4. your aftermarket exhaust isn’t touching anything it shouldn’t, including your *handbrake cable and assembly*

5. no oil leaks, GB leaks, radiator leaks etc etc etc

Wheels & Suspension:

1. your wheel alignment is reasonable (ie wheels aren’t touching, or nearly touching, any suspension componentry)

2. wheels are legal. If you’re not sure, check. A general rule of thumb is that u can go 2” rim diameter greater and 25mm wider, but check with regency before you go thru. Rules are different for each model, and for different manufacturing years.

3. tyres in good nick, including your spare tyre.

4. brakes are good. Callipers are legal.

5. your ride height is as close to stock as possible.

Engine & Drivetrain:

1. you’re not blowing smoke

2. your aftermarket pod is secured. Afm is plugged in, O2 sensor is plugged in. inputs (sensors etc) are plugged.

3. your egr is plumbed in and functional.

4. no structural rust

5. you have documentation to demonstrate that anything non standard meets the relevant Australian Design Rules (ADRs) and Australian Standards (eg steering wheel)

6. If you have a visible aftermarket ecu be prepared for an emissions test. It isn’t wise to go thru with anything non standard, especially if it’s visible.

Your Attitude.

1. Be cool, friendly, and relaxed.

2. Demonstrate that you respect their rules and knowledge.

3. Remember your manners

4. If they pull you up on anything, politely ask what is needed to make it legal.

5. Bite your tongue. They don't like attitude.

so even if coil overs are set at or above standard required height its an issue?? from that impressive list you have that is my only downfall :D

yup. any form of adjustable suspension is an issue.

I've got a clunk going on in the front right suspension, probably a worn bush but I'll get it looked at. Seems from that list only thing that would get me is ECU and ride height.

Spare tire...what about the wheelbarrow tire? IE: Space saver?

I also heard that tears in the seat fabric are bad, I've got the standard R32 GTR hole in the drivers side seat...

hey questions, can they send you all the way to regency of they defect you way out in country SA somewhere? would seem a bit stupid having to travel all the way to adelaide just to clear a defect? they would just send you to the closest cop shop in this situation?

Well when I was defected in Adelaide and not sent to regency, the car was registered in Port Lincoln.....

I've got a clunk going on in the front right suspension, probably a worn bush but I'll get it looked at. Seems from that list only thing that would get me is ECU and ride height.

Spare tire...what about the wheelbarrow tire? IE: Space saver?

I also heard that tears in the seat fabric are bad, I've got the standard R32 GTR hole in the drivers side seat...

Space saver is fine, as it came stock with the vehicle. Just make sure it is secured.

Will be interested to see how you get on with the turbs. Was recently told that Regency had wised up to the swapping of similar looking turbos and that nothing but stock will get you through. Don't know how they can tell and it could all be a pile of steaming dog shyte so let us know how you get on.

Bigger turbo/changed turbo will be a huge defect due to it changing emissions. I cannot see that a R32 GTR stock turbo will look the same as a R34 N1 turbo. Plus the model numbers will be different.

The only turbo modification you'll get away with is if you've steel wheeled a ceramic wheeled R32 GTR Stock turbo, and possibly high-flowed it, as they'll only check the model number, etc on the turbo.

I had a mate who has a R32 GTS-t who went through Regency with a bigger HKS turbo. He got done for it, and got sent to get a full emissions test.

I've got a clunk going on in the front right suspension, probably a worn bush but I'll get it looked at. Seems from that list only thing that would get me is ECU and ride height.

Spare tire...what about the wheelbarrow tire? IE: Space saver?

I also heard that tears in the seat fabric are bad, I've got the standard R32 GTR hole in the drivers side seat...

They wouldn't care about the appearance of the seat (rips in it - unless they're incredibly deep like someone has gone on a seat stabbing rampage) providing that:

1. The seat is secured, bolted down, and the back rest doesn't have any play in it (I got done for this back in my Familia, my back rest in the drivers seat had the slightest play in it, and I got pinged for it)

2. The seat belt can't have any frays in it on the fabric

3. The seat belt has to retract by itself and not just hang there once you've pulled it out

4. The seat must be standard (but by the sounds of it, yours is)

Well when I was defected in Adelaide and not sent to regency, the car was registered in Port Lincoln.....

Yes, if you're registered address of the car is a certain amount of kilometres away from Regency, they will send you to the nearest police station/checking station. So in your case, you'd get sent to the local cop shop regardless of the defect.

Edit: Check all your bushes!! This is a huge thing they like to check! If any of them are worn, replace them before you go through!!

Edited by CRoNic...
That PDF is way out of date.

Speak to Vehicle standards they too will tell you it has changed.

For example the R32 GTST used to be 360mm all round.

Now its 345mm front 355mm rear.

Here's the current version.. i called up Vehicles Standards and asked the gentleman to send it over.

IB44__August_2008_long_Version.pdf August 2008

I also heard that tears in the seat fabric are bad, I've got the standard R32 GTR hole in the drivers side seat...
They wouldn't care about the appearance of the seat (rips in it - unless they're incredibly deep like someone has gone on a seat stabbing rampage)

i got stung when i had my 31 go thru a few years back. the seat was slightly worn, and they reckoned they could "feel" the hinge in the seat. So best to go thru with no tears/excessive wear if possible

for just one defect are they really going to go over your car with a fine tooth comb??

Absolutely, no doubt about it, happened to me about 5 months ago. They will crawl in, on, over and under the car. They'll use a torch to look into the dark recesses and may even ask you to drop your pants and bend over, they are very thorough.

You can go into Regency for a blown light bulb and come out with a $3,000 list of repairs.

Have been told that they are now checking turbo serial numbers but don't know if this is true or not.

i got stung when i had my 31 go thru a few years back. the seat was slightly worn, and they reckoned they could "feel" the hinge in the seat. So best to go thru with no tears/excessive wear if possible

So if my seat is worn down from getting in and out (as in, the bucket side of it) so its gone a bit flat, and if they press on and it and can feel the hinge (I take it any metal in this area) then thats a defect?

I also heard a week or 2 ago that over the next 6 weeks the cops are having a crack down on all Jap imports. Heard from a cop who pulled this person over. I would show the txt message but lost it.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...