Jump to content
SAU Community

Recommended Posts

  • 2 weeks later...
Hey guys just wondering if it's a straight forward swap? The reason for is because it is white with the red needles and that would match the gauges I'm planing on getting.

I'm looking into this too. The circuitry on the back is pretty simple. Here is what I have found so far:

Left side pins:

Oil/Boost Earth

Oil Temp Signal

Boost Signal +

Boost Signal -

Right side pins:

Illumination Earth

Battery Earth

Illumination 12V

Battery 12V

The voltage and illumination is no problem, just tap into the radio loom. But you will need to find GTR sensors for the oil temp and boost.

  • 2 weeks later...
I'm looking into this too. The circuitry on the back is pretty simple. Here is what I have found so far:

Left side pins:

Oil/Boost Earth

Oil Temp Signal

Boost Signal +

Boost Signal -

Right side pins:

Illumination Earth

Battery Earth

Illumination 12V

Battery 12V

The voltage and illumination is no problem, just tap into the radio loom. But you will need to find GTR sensors for the oil temp and boost.

would be an awesome swap... is there any mods needed to do to the dash to fit?

There are differences in the pin configuration for r32 series cars for certain years, try it and see.. I have a late r32 gtr dash in an early r32 gts4. Lots of electrical crap was wrong but it is easy to shift the wiring around in the connector.

There are differences in the pin configuration for r32 series cars for certain years, try it and see.. I have a late r32 gtr dash in an early r32 gts4. Lots of electrical crap was wrong but it is easy to shift the wiring around in the connector.

Cheers guys, have to get hold of a cheap cluster and see what I can come up with.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...