Jump to content
SAU Community

Recommended Posts

hi there guys, i just bought my r34 gtr vspec its got the on board digital computer it seems to get hot every time i give it a fang the temperature reaches 105 but when im cruisin it sits between 90 and 98 is that ok or is there something wrong and the car is completely standard thanks

Link to comment
https://www.sau.com.au/forums/topic/257158-r34-gtr-v-spec-over-heating/
Share on other sites

If you're the 1st owner in Oz, it is 'best practice' to replace the Jap water/coolant and replace it new stuff. This policy can save you from a new radiator, heater core etc. This is the start of your process of elimination. Congrats on your new acquisition!!!

^^Good stuff!

I use Tectaloy 100 radiator coolant, which is pre-mixed and designed for Turbo cars.

Also if you want to enhance your cooling in the engine bay, you can install a R34 GTR V-Spec II carbon fibre bonnet as they have a NACA duct positioned above the twin turbo system and it would give you extra cooling.

They are a straight fit bolt on.

Unless you have a V-Spec II than all is good...

^^^

There are a couple of different rating thermostats available, one of which will do that. Certain BMWs capitalise on the availability of these too.

And since you've already changed the coolant, you didn't forget to bleed the remaining air out did you? Your temp will go up if there's any air left in there.

would a 52mml alluminuim core raidiator keep it cooler or keep the temp lower than standard raidiator???
Doubt it (refer latest HPI)

Isn't 98 a bit hot for "cruise", ie low load? That would suggest a problem with the water pump - occasionally the vains rust away and it can't circulate coolant as efficiently.

If you upgrade your radiator, it will help with cooling, but if your not doing any serious track work, there is not much point... But dosen't hurt to change it either.

You might want to check your water pump, but I doubt it will be the problem.

On a hot day, your temps will always sit alittle higher then on a cooler day.

I would keep a look out for your oil temps too... Does it go up like your water temp or is it sitting at a regular temp?

I dont see any higher thatn 83-88 for water temps (on a 38 degree day it reached 90 but i put the heater on the bring it down)

oil temps are about 81 on a cold night and go as high as 85 on a hot day cruising but ive never seen higher than 90degrees ever

From memory thats seems fine on a hot day as my car can get to those temps too. + it depends if you run your A/C or driving up a hill, anything that requires the car to be rev'd alittle harder with effect the temps. Again its normal.

Normal crusing temps are just under 90 degrees.

From my understanding, the R34 GTR's seem to hold quite a consistant temp, even with a bit of a fang.

My friend Tim GTR on SAU has a R34 GTR V-Spec, I took it out for a run, hammered it down the straight and a few corners, then check the MFD with the oil and water temps and they seem stable and yes within that range from about 91 to 98, I think it sat at about 93 degrees C.

What engine oil you using?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
    • It's needed for rolling idle up, and I think it is a decider on VCT also.
    • I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...