Jump to content
SAU Community

Recommended Posts

hey, i ve got a r33 rb25det..

for lik a week now..ive bein noticing weird hesitation..well more like little missfires.. or splutters would be the word im looking for..

from i believe it only wen de-acceleration..

lik ive back off the throttle to like change gear for example..or just back off...

but wen i go to accelerate again..it does it..so its not a boost thing..

and im not acclerating hard or full throttle..like 10-20& throttle...so like just from daily driving...so im not evan close to hitting boost..

my mates reckon it sounds like a vac leak..

wen driving..the only thing i can describe it just feel lik ive dropped in power for lik a spilt second...u can feel it in the accelerator pedal...and u can hear here abit..

well the splutters..

but not all the time does it do it...its so weird..

ive changed new plugs and there gap to 0.8m..

clean afm with afm cleaner..

clean iacv wit carby cleaner..

and ive check for vac leak..cant here anything..

did check all silicone hose..just incase and there hose clamps...

and they seem all good...

any ideas?

my engine mods are

walbro fuel pump,fmic,pod,splitfires,apexi afc neo, hks catback exhuast,hypergear atr28 g2 turbo,hdi type-d ebc

could be injectors, could be the tune in the AFC but if it's only been for a week that's not likely. I would suggest having the injectors ultrasonically cleaned. Also make sure your TPS doesn't have a dead spot at that throttle position. Voltage check it while slowly bringing on the throttle.

This happened long time ago to our test car. Its from the turbo's dose. Happens when turbo throws air out to wards the AFM and then suck it back in. After I put the AFM in side cooler piping this issue was solved.

hey 33gtst,,

wat do u mean by low and light throttle cut??wat did it feel like??can u explain it abit more??

or did u have any other noticable issues that appeared too?

thanks

I just had this similar issue, after a tune last week.

last night replaced the spark plugs with new ngk bcpr6e .8mm plugs

had the battery disconnected during the job, reset and its all fine now.

na, its got a atmo bov..

but its set on hard..

so it completely flutters..

but the problem..is on off..

like it will do it lik 1 out 3 days..

sometimes 4 days..

its freakin annoying!

my recommendations

fit the std bov in plumb back mode

replace with a known working AFM

the likely suspect is your BOV, its probably venting vacuum pressure and its enough to annoy the AFM

which makes the car stutter and hesisate

well...i think ive faulted my problem..

i noticed wen on the freeway the other night..

i notice on my afc..that a/f% was on about 10%..then all of a sudden it would just randomly drop to lil 7/8%

nad i could feel the hesitation from this...it did it a couple of times..then it just went away.. ????? :D

but my throttle was in the same position...just cruisin..no boost or anything..

so what i can gather from this this its the afm cutting out..

i just open the silicone top black cover on the top off afm.

noticed the 3 wires that connect to the main board looked fine..

but i still did re-solder them...

and i gave the board a good clean of electrical contact cleaner...

hopfully shes all good now :P

Mine has the same problem, only happens when just opening the throttle off idle or 0%.

I'm running a microtech ecu with no afm.

the cause of mine is the throttle position sensor, i can watch it on the laptop and when the throttle is closed the throttle percentage creeps all over the place until i touch the throttle.

like 3lit3 32 says, "dead spot in the tps"

but at $208 i have not ordered a new one yet.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...