Jump to content
SAU Community

Recommended Posts

i did the change. also went from a pfc to a wolf v500, with a much more in depth tune so i can't really coment on possible response loss, as i actually gained a lot of throttle response.

only ill effect i noticed was a small increase in the amount of times the car cranked over before it started. like maybe half a second.

There are many automakers who use MAP based systems with no problems at all, so why would you have problems with a map based standalone? If there were problems you can probably chalk it up to bad tuning or just a poorly designed standalone. I have zero problems with my standalone map based system even though I have a 5bar map sensor. Cold start, Drive-ability, Closed loop wide band Cruise, and deceleration are perfect.

Edited by maximajim

I went from ECR33 PFC L-jetro and converted it to run the GTR's D-jetro, Being that I mapped both setup's I can say this, the D-jetro was much easier to get nice dead stable AFR's, Drivability is better and fuel consumption is up by .5L better per 100km. (this was with no other mods done at all besides ECU change, I use FCedit, dual widebands, EGT and dual knocklinks when mapping RB's)

Best thing, no idle mess around! car just runs better all round. D-jetro's idle stabilization by timing is fantasic as well! almost as good as VEMS's

so far then .. it sounds all good.

I wasn't told map has any "problems" but that it isn't a good choice if you plan

to do mountain driving, as altitude (or big temp changes) muck with the tune vs maf.

My tuner says map will "feel different" in a possibly negative way, he didn't elaborate.

And people on sau have posted before that map is 'for race cars' and maf is for street,

and someone else on sau said map didn't work as well with multiple throttle bodies.

So I figured I'd ask if people had experienced a car before vs after with as much else

the same.

Edited by moneypit
I would say buy a ecu based on his recommendation or find another tuner who is competent in tuning a map system.

He should know that a good standalone will have temp and barometric trims (if needed).

He recommended going map, ecu is hks f-con,

but he just said it will feel different, and indicated I might not prefer it.

MAP sensor here too. Given the choice, i'll always go MAP over AFM. The number of AFM related issues that seem to pop up all the time is crazy. I went through 3 AFMs on my old car, and it still never was quite right.

MAP sensor here too. Given the choice, i'll always go MAP over AFM. The number of AFM related issues that seem to pop up all the time is crazy. I went through 3 AFMs on my old car, and it still never was quite right.

100% agree

MAP user here :D

so far then .. it sounds all good.

I wasn't told map has any "problems" but that it isn't a good choice if you plan

to do mountain driving, as altitude (or big temp changes) muck with the tune vs maf.

My tuner says map will "feel different" in a possibly negative way, he didn't elaborate.

And people on sau have posted before that map is 'for race cars' and maf is for street,

and someone else on sau said map didn't work as well with multiple throttle bodies.

So I figured I'd ask if people had experienced a car before vs after with as much else

the same.

The issue with multi throttle bodies and MAP, is the turbulunce.

You can get the same MAP reading, for a different throttle reading, and it plays havoc.

Good ECU's, like the Adaptronic, Motec, (I also believe Haltech, ViPEC and Autronic) run MAP vs TPS tuning.

I run MAP with the Adaptronic, and it has no issues at all.

Actually, it has quite a few benefits... I can run NO BOV, and not have a single issue.

I run an oil coated air filter, and not have it flood my AFM giving shit readings, resulting in poor idle...

Yeah mine doesnt take long to crank, and doesnt hunt on cold start. It does everything "normally" compared to an AFM based ECU.

....Well, except for having dramas when the AFM's get dirty and play up :D

Ford XR6 Turbo runs map and no issues there. So the whole map = race car is a little off.

The 1JZ and I believe 2JZ also run MAP...

Lots of manufacturers cars run MAP from the factory

My car takes a couple of cranks to fire, but that is purely the ECU, and NOTHING to do with it being MAP based.

I went through 3 AFMs on my old car

Brand new each time or 2nd hand? I'd be interested to hear the reasons why 3 brand new AFM's would have died in a short period.

If 2nd hand, then well... thats pretty much a pointless statement :D

Every AFM that i put in (new) works/worked fine without issue.

Ive played around with 2nd handies lately (due to time constraint) and had nothing but problems, but i accept that because im playing around with used parts and not brand new ones.

That said - go with what the tuner reccomends. He is tuning it afterall...

Straight MAP was poor on light throttle compared to AFMs but I had multiple throttle bodies (RB26). Redid the tune with MAP over TPS (combination of the 2) and found driveability every bit as equal as stock AFMs.

Best point => if I blow a cooler pipe/vacumm hose at the drags I can drive it home as is... unlike AFMs which would instantly foul the plugs. Best move I ever made was getting rid of the AFMs.

I went for a MAP because my tuner prefers it, he put it this way to me, although the AFM is a good bit of gear he has had more problems with that one piece of equipment than any other but finding out it is the AFM to be the problem is the real reason he prefers the MAP sensor, as for driveabilty I didnt really notice anything except the power increase.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah that is not actually a lot. Just painting my GTR frontend and the little bits to make sideskirts/nismo flare pieces work correctly/fit on the sedan/mount up correctly came to about $7000. Is it a lot? Sure. None of this is economical. Economy would be shelling the car and buying a 2010 Corolla to commute in. The perspective of all of this is different.
    • I have the 2025 build re003s’ on my 06 XT Forester Turbo and I quite rate them for street wet and dry
    • I don't see any issues here. I've been saying all along this is a big job, the price reflects that.  When the car comes back perfect I'm sure it will feel like money well spent. 
    • Remember, take original quote. Double it. Then add a bit more. It's how any project goes.
    • So, I started this repair and got as far as "fixing" the holes with some fibreglass. God all those years working on boats came back quickly. I decided I'd reach out to some rust guys just to see what they would say about it. I came across a guy about 40 mins away and went to see him. He said the windscreen needs to come out, that there might be some more bits around the windscreen and he'd quote them at the time. But his quote was $300 to remove and replace windscreen and $3k for the damage he can see. He said he could respray the roof for $1200 and the bonnet for another $800 (somebody has previously rattle canned it, its horrendous). This is $5300 + any small additional bits. It's a lot, I get that and the name of one of my fave youtube channels 'Not Economically Viable' comes to mind.  I'm not being financially rational, but I've taken him up on the quote. He's opening a new shop in November with more room, so we're waiting for that. I'll leave the currently missing headliner out until then. I'm looking forward to it being fixed and having the paint looking nice again (lots of clear coat issues on the roof too). / flame suit on.
×
×
  • Create New...