Jump to content
SAU Community

Recommended Posts

What brand is the exhaust/intercooler and is that price fitted.

[/quot

ye there both fitted from XSPEED

exhaust system:

xforce turbo back exhaust(m/steel)

3"system

3"racing hi flow cat

3" centre muffler

3"s/steelcannon muffler (angle)

genuine nissan gasket

intercooler system:

DWR intercooler kit

-600x300x75 B+P intercooler core

-aluminium piping

-silicon hoses

-hose clamps

So you have a boost controller then? leave it at or under 0.8bar if you have a standard ceramic turbo.

A new intercooler and exhaust have the potential to increase general flow and/or decrease flow resistance and will give a little extra power regardless of boost.

I made that up like the moon landing...

So you have a boost controller then? leave it at or under 0.8bar if you have a standard ceramic turbo.

A new intercooler and exhaust have the potential to increase general flow and/or decrease flow resistance and will give a little extra power regardless of boost.

I made that up like the moon landing...

ahah thats gold lol

ceramic turbo? and o.8 how much is that in pounds?

1 bar is 14.7 psi

most people run 11-12psi on the standard to make it last

any more and its running on borrowed time

If that price is fitted its not to deer

you will however need a ecu whether it be piggyback or full ecu

then a tune

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...