Jump to content
SAU Community

Recommended Posts

G'day

my stagea has just clicked over to 85000 ks and with the snow season just around the corner i figured i should get any major service work done sooner rather than later

The car is pretty much standard with hi/lo boost switch and a pod filter... its a series 2 stagea (rb25 neo)

What i was thinking of doing was the following

- timing belt

- spark plugs

- clean pod filter (k+n)

- oil change

- bleed brake system / new brake fluid

- usual check fluid levels ect ect

the brakes have been re machined and new lining on the pads about 5000 ks ago

anything else i should do

i usually use gulf 1 - 10w60 synthetic oil in it

what spark plugs should i use?? any recommendations of which ones to use, or which ones to stay away from

what timing belt should i get i have seen those gates timing belts but maybe i should stick with the genuine nissan one seeing how critical a timing belt is and the fact that my engine is standard aswell, although gates belts are usually pretty high quality belts i think i would trust a geniune nissan one...

Thanks in advance

Rick

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/
Share on other sites

If youre planning on keeping the car for quite a long time, things I would do would be everything you have listed plus:

Get a hold of one of the just jap timing kits - they include gates belt (yes they are as good as nissan if not better), tensioner and idler bearings, cam and front main oil seals.

Have all of that fitted, and while youre at it, replace the water pump just for good measure..theyre only like $80 odd from nissan and 15mins to fit.

Off the top of my head i think the plugs you need are the BCPR6ES NGKs.

If they havent been done while you have owned the car, think about the gearbox, transfer, diff and ATESSA oils.

Once again if youre padantic, change the oxygen sensor as well. Expected life of those is about 100,000kms.

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/#findComment-4629051
Share on other sites

if you are in somewhere that gets snow, personally i would be going to a thinner oil. a 60 grade oil is a rather thick oil, especially when the rated oil by nissan is only about 30 i think (think it might be 7.5w30). so unless you have a lot of mods (which you don't) or the engine has done a lot of kms (which it hasn't) or has oil usage issues, i would get a thinner oil (it will also give you better fuel economy). for cold climates, especially if the car will be parked outside during the day at all and most definately if parked outside at night, i would suggest something with either a 0 or 5 cold viscosity and about a 40 or at most 50 hot viscosity. unless you really thrash the car a lot a 40w hot viscosity will be fine, since nissan only had a 30w oil as the standard recommended oil.

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/#findComment-4629099
Share on other sites

Gday Rick, i can highly recommend the 100K kits from KUDOS motorsport. My brother has a STAGEA and he put in a 100K kit last week, i am going to put one in my R33 soon too. Great value and super quick delivery too.

http://www.skylinesaustralia.com/forums/Ni...vi-t137554.html

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/#findComment-4629201
Share on other sites

If youre planning on keeping the car for quite a long time, things I would do would be everything you have listed plus:

Get a hold of one of the just jap timing kits - they include gates belt (yes they are as good as nissan if not better), tensioner and idler bearings, cam and front main oil seals.

Have all of that fitted, and while youre at it, replace the water pump just for good measure..theyre only like $80 odd from nissan and 15mins to fit.

Off the top of my head i think the plugs you need are the BCPR6ES NGKs.

If they havent been done while you have owned the car, think about the gearbox, transfer, diff and ATESSA oils.

Once again if youre padantic, change the oxygen sensor as well. Expected life of those is about 100,000kms.

as above, but with Fuchs 10w30.

new wiper blades

radiator flush

new OEM thermostat

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/#findComment-4629257
Share on other sites

Gday Rick, i can highly recommend the 100K kits from KUDOS motorsport. My brother has a STAGEA and he put in a 100K kit last week, i am going to put one in my R33 soon too. Great value and super quick delivery too.

http://www.skylinesaustralia.com/forums/Ni...vi-t137554.html

Cheers.

kudos 100 000k service, are they all pretty much what u need for a 100 000ks?? and some upgrades as they listed.??

coz im thinking i might just get the whole kit from them instead of buying it one by one...

any advice in kudos 100 000 k service kit??

thanks guys

Link to comment
https://www.sau.com.au/forums/topic/272659-major-service/#findComment-4634247
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...