Jump to content
SAU Community

Recommended Posts

hey having trubles with my rb25det s2

well when i first put engine in my car would drive good but there has always had a very little hisitation from round 5500 to 6500 but hardly noticable

has fmic, exhaust, only ever run 9psi

but then it started backfiring hard between 5-6.5g

i decided to wire up up an ignitor and wasted spark

has new vn coil and leads with 8 months old platniums

checked them and the white ceramic was cracked on one and you could c were it had been arc'n through so replaced with a spare irridium ( if anyone knows wot 45 dollar ones to put in)

know when it gets to round 4500 it just misses/pings, doesn't even rev past 5 easly

it seems to change behaviour(getting worse)

tried changing cas but no change

Link to comment
https://www.sau.com.au/forums/topic/273798-rb25det-power-troubles/
Share on other sites

Hold on what. THIS IS BAD

You put 2nd hand plugs in it and VN coils? like commodore coils wasted spark ignition? why?

NGK bkr6es is copper replacement plug for these things.

PUT THE STANDARD IGNITION SYSTEM BACK ON!

the standard ignition system is fine... when working properly.

check timing

doulble check boost

don't drive car till it pings this will cost you another engine.

try turning CAS all the way clockwise to minimize ignition timing before you drive anywhere

get your Air fuel ratio checked asap any 4wd dyno place will do it to confirm fuel issue.

a chipped plug would confirm major detonation event has occured, unless it was damaged on installation or removal.

hey having trubles with my rb25det s2

well when i first put engine in my car would drive good but there has always had a very little hisitation from round 5500 to 6500 but hardly noticable

has fmic, exhaust, only ever run 9psi

but then it started backfiring hard between 5-6.5g

i decided to wire up up an ignitor and wasted spark

has new vn coil and leads with 8 months old platniums

checked them and the white ceramic was cracked on one and you could c were it had been arc'n through so replaced with a spare irridium ( if anyone knows wot 45 dollar ones to put in)

know when it gets to round 4500 it just misses/pings, doesn't even rev past 5 easly

it seems to change behaviour(getting worse)

tried changing cas but no change

I'm not surprised you have power troubles with mixture of irridium and platinum plugs, ignitor and dunnydore coils and leads.

I think you need to replace all your parts with parts that fit the application that are strictly for the RB25DET NEO engine and then get it tuned.

If you cannot manage this then take it to competent mechanic who can help (most should be able to get you sorted.)

And make sure your base timing is set to 15 degrees on your CAS and plug gap is at factory 1.1mm as a start.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...