Jump to content
SAU Community

Recommended Posts

  • Replies 714
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

What servo in Gawler where you looking at stopping at? There is a Caltex/Woolworths, Mobil, Shell, and 2 BPs. Unfortunately, both of the BPs have little to no parking. So it may be better to fill up at either On The Run @ Munno Para, or BP which is 300m further down the road from OTR MP.

Probably the one near the bridge in the middle of gawler (I'll be leading the crew in via the angle vale bypass and then out to tanunda/nuri... it'll be a very quick stop, simply to get petrol - will need to be either a BP or Mobil as nobody else stocks 98 octane

-D

Probably the one near the bridge in the middle of gawler (I'll be leading the crew in via the angle vale bypass and then out to tanunda/nuri... it'll be a very quick stop, simply to get petrol - will need to be either a BP or Mobil as nobody else stocks 98 octane

-D

The one right near the bridge (across the road from Holden) is a Shell - which infact is where I normally get fuel but its 95octane VPower. BP is about 1/3 of the way down on the main part of the main street on the left hand side.

http://maps.google.com.au/maps?source=s_q&...013304&z=16

The one right near the bridge (across the road from Holden) is a Shell - which infact is where I normally get fuel but its 95octane VPower. BP is about 1/3 of the way down on the main part of the main street on the left hand side.

http://maps.google.com.au/maps?source=s_q&...013304&z=16

BP it is then, point B on your map. looks good.

-D

Ben or anyone else, do you have a direct contact for the organizer of the event so I can get in contact with them........I think it's Stuart that's organizing the event, yeah?

Also can payment be made over the phone by credit card or EFT by any chance?

Sled and i are leaving at 2pm on the Friday and going though Murray Bridge if anyone is intrested in going that time please let us know . S

So are we all meeting up somewhere before and heading down together or whats the case on this???

I will have a set of ISC N1 Coilovers and Rear Camber Arms in the next few days, so my car will lose its 4WD spec suspension just in time for the show! It will also allow me to put my Rays Gramlights on. Stoked!

hmm, hopefully you can adjust those arms when theyre on the car. heard reports from a few people that they had to take the arms off everytime they wanted to adjust them.

I think so, REALLY hoping to get my ISC coilovers and camber arms in this weekend, that way I can lose the stock rims to make way for my Gramlights.

I actually got a letter from the Riverland Motorsport Club today with a brief schedule and also my car number (25).

A week to go people hope you are all ready ? :(

Nope..dont even have the car...hopefully have it tuesday.

I actually got a letter from the Riverland Motorsport Club today with a brief schedule and also my car number (25).

Same, i got mine today, entrant #13...not sure if that's a bad sign :S

Nope..dont even have the car...hopefully have it tuesday.

Same, i got mine today, entrant #13...not sure if that's a bad sign :S

rofl, yeah i got mine too, #52

just got back from the mechanic. some touchup paint yet to go, but the front spoiler lip and weezy's teins are now fitted

withspoiler1.jpg

withspoiler2.jpg

NOW the car is a a decent ride height. Contrary to what some (who havent seen my car) have said, it was way low before, only an inch clearance between the ground and the spoiler lip. Now I got 2.5 inches, which should be enough. The teins are pretty stiff compared to the bilsteins, but nowhere near as much as some people made it out to be. I'll know after loxton whether or not I'm gonna buy them (a good 3 hour drive there and back will decide it heh). Brakes also got bled for a 2nd time (as the seals in the caliper took a couple days to set) and now the brakes as firm as megan fox's arse...

Oh and my boot release latch is working again. Porn you can't see.

-D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
    • Does the scanner do all the CUs in the car, or only the ECU?
    • @666DAN sorry to bring you and old thread.     I've got my de+t done and it's all running great other than 1 small issue.    Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd when selected . But nothing when in  drive or what gear your in when you pop it into tiptronic. I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Do ya have any ideas?     Cheers man
    • Well I recently changed my rear axles and was thinking if I bumped anything, I have been driving the car for a while now though... But it has been raining today so everything is wet under the wheel arches. Brakes feel fine and can't hear any of the metal screamers, I had a squeak coming from one of the handbrake drums but that seems to have gone away a while ago. I was going down a hill when it lit up and I did feel the abs bite for a second and question why it did it?
×
×
  • Create New...