Jump to content
SAU Community

Tyre Selection For A Wet Track

LotusGTR
 Share

Recommended Posts

Roy Grand Master

Roy

Posted
Posted

LOL, man if its real wet and raining go out with 34psi. If its damp and not raining go out with 32psi. At the end of the first sesssion jut check them and have a think about how they felt.

LOL, thats what i would do...lol problem is it may not be the correct thing :)

LotusGTR Veteran

LotusGTR

Posted
  • Author
Posted
LOL, man if its real wet and raining go out with 34psi. If its damp and not raining go out with 32psi. At the end of the first sesssion jut check them and have a think about how they felt.

LOL, thats what i would do...lol problem is it may not be the correct thing :(

Lots of lolling going on at your end! Must be having a good time :)

Cheers for the advice, it's sort of patchy rain so I'll go for 32.

LotusGTR Veteran

LotusGTR

Posted
  • Author
Posted

Just in case someone searches for this later I've done the trackday and the r compounds were great in the wet. It was amazing how much heat I got into them. It took a couple of laps to get the heat in but once done they gripped a treat. I'd highly recommend them if available.

LotusGTR Veteran

LotusGTR

Posted
  • Author
Posted
re01r's are pretty much a semi anyway , i would've gone with them!

My RE01Rs look, feel (to the touch) and drive nothing like my RE55s. Add to that different sidewall construction and I'd argue they are very different tyres and not comparable at all. I'd say an RE01 is simply a high performance road tyre. RE55s etc are a road legal track specific tyre, which IMHO are the most appropriate choice on all but a flooded track (based on a trackday I did on Sat). 5-7 fast laps on a soddent track with ambient at about 8 degres and they were very warm to the touch and generated heaps of grip.

R compunds all the way at the track.

JAGR33 Grand Master

JAGR33

Posted
Posted
re01r's are pretty much a semi anyway , i would've gone with them!

Errr, that is far from the truth...

RE01R's are not a semi comp tyre and cannot be compared to RE55's.

RE55's are in a different league...

And yes, I've been to the track with both... :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • GTSBoy
      Unpeeling the Orange

      By GTSBoy · Posted

      Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • Kinkstaah
      Unpeeling the Orange

      By Kinkstaah · Posted

      The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
    • MBS206
      What brakes on R34 GTT(Europe)

      By MBS206 · Posted

      For DBA, check out their guide table here. https://dba.com.au/wp-content/uploads/2023/01/Direct_Replacement-Guide-2021.2.pdf   Additionally they have some other guides and info on how to make sure you choose the right pad.
×
×
  • Create New...