Jump to content
SAU Community

Recommended Posts

Black cluster. (S1)

No dimmer control. Lights piss weak.

In my R30 you can control the power windows AFTER the ignition has been turned off. That was the crowning glory of the R30 and why I have had four of them and still have two.

Arm ripping location of oil filter. Now have relocation.

Apart from the above the Stagea is PERFECT.

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/
Share on other sites

i take it this is going to be similar to the good bits thread?

if so:

The STUPID top facing intake manifold - Lets make the most basic of all service procedures take 15 times longer.

The plastic bung in the rad that requires a screwdriver to open *facepalm*

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4732972
Share on other sites

S1 auto not tiptronic

all turbo's across the range C34/M35 should have been garrett gt3076-spec from factory

S1 ecu modifiable without the need for a 48pin-84pin chip adapter to house the remaped chip

S1 and S2 should have had silvia s15 JDM 450/480cc injectors standard

S1 and S2 swaybars should have been thicker

think thats about it, along with the above comments

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4732989
Share on other sites

Yep Tangles but was thinking more along the lines of generalities in design, rather than performance.

If you throw ten grand at a Stag it will go like a 911, but the effin windows still wont close unless you turn the key on.

Why did Mr Nissan do away with this feature?????

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733078
Share on other sites

Yep Tangles but was thinking more along the lines of generalities in design, rather than performance.

If you throw ten grand at a Stag it will go like a 911, but the effin windows still wont close unless you turn the key on.

Why did Mr Nissan do away with this feature?????

I know, and I still reckon the Stagea should have come with a bigger turbo and definately fatter swaybars

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733311
Share on other sites

Wing mirror and front shock towers prone to rust.

Cost of manual centre console ($2k or so, if you go genuine)

sun visors that look like crap as soon as they're a few years old

weather strips that break easily and are almost impossible to get replacements for.

no bi-fold console lid in S1

Dayz side skirts always seem to go misshapen near the rear wheelarch

That said, I always found my (S1) headlights to be very good, and I didn't mind the standard seating position (but my recaros sit a little lower, and it is significantly better)

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733452
Share on other sites

front guards under wing mirrors and front shock towers prone to rust.

Cost of manual centre console ($2k or so, if you can get one)

sun visors that look like crap as soon as they're a few years old

weather shields that break easily and are almost impossible to get replacements for.

no bi-fold console lid in S1

Dayz side skirts always seem to go misshapen near the rear wheelarch (end cap pops out)

That said, I always found my (S1) headlights to be very good, and I didn't mind the standard seating position (but my recaros sit a little lower, and it is significantly better)

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733453
Share on other sites

if it's design faults you want, the clock on the dash is further away than it should be and there's not many practical spots for gauges, lol, although i doubt that's what they think of when they're designing a car :laugh:

front guards under wing mirrors and front shock towers prone to rust.

Cost of manual centre console ($2k or so, if you can get one)

sun visors that look like crap as soon as they're a few years old

weather shields that break easily and are almost impossible to get replacements for.

no bi-fold console lid in S1

Dayz side skirts always seem to go misshapen near the rear wheelarch (end cap pops out)

That said, I always found my (S1) headlights to be very good, and I didn't mind the standard seating position (but my recaros sit a little lower, and it is significantly better)

!!! i thought that was just ours! the wife's stag looks like somebody's just stuck a dayz kit on it (missing the rear of it though) and i thought it was just poor fitment, haha.

Edited by pyro-ns
Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733533
Share on other sites

Already mentioned, but:

+1 on the window controls

+1 on the door rust

+1 on the dimmer (or lack thereof)

+1 on the oil-filter location (and subsequent farkin mess...)

The biggest problem is that Nissan never imported them here, so we've all had to wait 5+ years to get hold of one...

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4733812
Share on other sites

stupid rust on strut towers

not enough leg room

no remote start on manuals (dumbest f**kin idea ever)

shit hack single core radiator (slack f**ks )

wtf doesnt it have 4 pot brakes standard ( i have more power standard and more weight than a skyline so why the 2 pots)

space saver that is too small and upsets atessa

odd ball standard tire size on 17s on rsfour s

stupid f**kin hicas rack that the motor points straight down under the diff and gets ripped off when a 33 gts25t one bolts straight on and is way up out of the way

front sunroof doesnt open f**k all

they way my enging runs 10 psi standard but they havent tuned ecu f**k all so with an exhaust and intercooler and the boost turned down so it still only runs 10 psi and it runs rich as and pulls timing

back seat base is nothing more than a big wad of seat shaped foam

no factory oil cooler (r34 gtt got one . wtf didnt i )

thatll do for now

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4734196
Share on other sites

stupid rust on strut towers

not enough leg room

no remote start on manuals (dumbest f**kin idea ever)

shit hack single core radiator (slack f**ks )

wtf doesnt it have 4 pot brakes standard ( i have more power standard and more weight than a skyline so why the 2 pots)

space saver that is too small and upsets atessa

odd ball standard tire size on 17s on rsfour s

stupid f**kin hicas rack that the motor points straight down under the diff and gets ripped off when a 33 gts25t one bolts straight on and is way up out of the way

front sunroof doesnt open f**k all

they way my enging runs 10 psi standard but they havent tuned ecu f**k all so with an exhaust and intercooler and the boost turned down so it still only runs 10 psi and it runs rich as and pulls timing

back seat base is nothing more than a big wad of seat shaped foam

no factory oil cooler (r34 gtt got one . wtf didnt i )

thatll do for now

Good thing this is a car you like, I'd hate to see the list for a car you don't like... :down:

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4734217
Share on other sites

stupid rust on strut towers

not enough leg room

no remote start on manuals (dumbest f**kin idea ever)

shit hack single core radiator (slack f**ks )

wtf doesnt it have 4 pot brakes standard ( i have more power standard and more weight than a skyline so why the 2 pots)

space saver that is too small and upsets atessa

odd ball standard tire size on 17s on rsfour s

stupid f**kin hicas rack that the motor points straight down under the diff and gets ripped off when a 33 gts25t one bolts straight on and is way up out of the way

front sunroof doesnt open f**k all

they way my enging runs 10 psi standard but they havent tuned ecu f**k all so with an exhaust and intercooler and the boost turned down so it still only runs 10 psi and it runs rich as and pulls timing

back seat base is nothing more than a big wad of seat shaped foam

no factory oil cooler (r34 gtt got one . wtf didnt i )

thatll do for now

Tell us how you REALLY feel! :rofl:

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4734379
Share on other sites

Bad bits?

RS boost gauge failures.

OE turbo exhaust wheel... poo ceramic doesn't last!

That is all.

Yes it does. If you want to flog the guts out of ANY vehicle, it has to be built to suit your bent.

I drive pretty hard on occasions. But there is a big (mental) difference between a hard (on) and a flog.

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4734516
Share on other sites

...

wtf doesnt it have 4 pot brakes standard ( i have more power standard and more weight than a skyline so why the 2 pots)

...

no factory oil cooler (r34 gtt got one . wtf didnt i )

thatll do for now

I must respond :P

The brakes are as-per C34 Laurel Sedan, but I agree that with the wagon platform, they should be bigger.

The Series 1 has an oil cooler (adjacent the filter), doesn't the series 2 have the same setup?

And, The S1 trans cooler is a bit piss-weak, but I'm sure it's fine in Japan :)

Link to comment
https://www.sau.com.au/forums/topic/280542-the-bad-bits/#findComment-4734818
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'd be very surprised if you can buy new OEM mats. But if you can, I want some too!  Do you have links to the variations you found? Also, where are you located? I found that Nengun is happy to list items to purchase but when you do buy them you'll get an email that it's actually discontinued. As far as I know the variations in floor mats are different colour schemes as well as automatic and manual having a slightly different shape. The automatic ones fit into a manual car without issues, but I think you'd have trouble fitting the other way around. I have photos that show the shape difference if you care. FWIW I bought sets of used floor mats in decent condition at yahoo auctions.
    • Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
    • Hi, Marek here 🙋‍♂️. I finally fulfilled my longtime dream - recently bought Stagea and now waiting for it to arrive in Poland. There's only few of these in my country, and one of the owners  recommended mi this forum as a source of all the info i'd need since now i own one  so here i am.  
    • Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
×
×
  • Create New...