Jump to content
SAU Community

Recommended Posts

  • Replies 340
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

mines snow performance. its got a MAP sensor in the control box under the bonnet, when it hits XX psi it starts injecting and by XX its on full so it ramps up the pump based on boost so you arent injecting silly amounts all the time.

water meth injection, its not expensive and gives similar/same results as using E85.

And E85 is cheaper then regular ULP when you buy it at the pump... Runs cooler... You only have to worry about keeping one tank topped up... No extra weight...

Remember, WMI also increases your compression again... So if you go super high CR, you're at risk of bending shit.

And E85 is cheaper then regular ULP when you buy it at the pump... Runs cooler... You only have to worry about keeping one tank topped up... No extra weight...

Remember, WMI also increases your compression again... So if you go super high CR, you're at risk of bending shit.

i am not saying E85 is a bad fuel but in Canberra you cant get it at the petrol station and you cant get it in Goulburn, there is not enough demand for it to be put in considering the relatively small spread out population when you look at Melbourne with 2 stations covering the whole place.

E85 does have negatives too, it uses 30% more for the same power figure (which brings it inline with 98 prices), requires a much larger fuel system to support it, it cant be left for too long as it absorbs water (granted petrol also goes off if left too long), have to keep an eye on your oil as it can contaminate it if the engine isn't running long enough to get the oil up to temp.

WMI with a sufficiently sized tank (like my 9.5L tank) can go for months without checking (street driving though 9.5L is still a lot for track driving) even the smaller tanks last a fairly long time unless you have your foot in it everywhere you drive. WMI also cools the intake charge like E85 does and when setup correctly you can even go so far as to run 91ron petrol and still make good power. (in some cases remove the intercooler completely as well)

there is a new project for you when you are done with the supra steve, 4wd twin turbo V8 skyline.

Haha that would be pretty special! Someone has done that in an r33 gtr in Europe, I think. It was Denmark?

Next for me is the Ultima, v8, 7.3L, 990kg

Nah nothing as exotic, Eagle stroker in an LS Chevrolet block

Now you mention the Zonda motor I'll look up specs just for a laugh

It will have the lightest rotating assembly as possible though

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...