Jump to content
SAU Community

Recommended Posts

  • Replies 650
  • Created
  • Last Reply

Top Posters In This Topic

Unfortunately I MAY have to pull out of this, suspected head gasket problems on my 26. I'm booked into Willall for a tune this Wednesday so I'll find out for sure then, fingers crossed it's nothing, if not, out comes the engine and rebuild time!

Unfortunately I MAY have to pull out of this, suspected head gasket problems on my 26. I'm booked into Willall for a tune this Wednesday so I'll find out for sure then, fingers crossed it's nothing, if not, out comes the engine and rebuild time!

Going stroker build and all if this is the case?

Seems to be the month for it... what happened?

drove through a huge puddle of water like an idiot... should have slowed down but didn't think it was that deep.

went from 60 - 10km/h in 3 seconds... then engine stalled. ended up sucking in water through the pod, milky engine oil, blowing smoke.

head gasket is ok, coolant is fine, no bubbles and such, no discoloration. flushed engine 3 times, put new plugs in it, starts and runs fine but is blowing clear white/greyish smoke constantly. really hoping its just the condensation from all the water that went through it.

last flush oil came up nice and clean, gonna put my regular synthetic oil in tomorrow morning and take it for a spin, see if the smoke clears out and then compression test it.

:)

if all else fails... 25/30 kicks in to motion.

wasent that january? or was jan the month for spun bearings, sept the month for low compression?? =P

What actually happened when you spun your bearing? High RPM range? Oil starvation? I'm scared to death one day my oil pressure will just drop off and spin a bearing haha. Over reacting I know but still.

How long untill you think your going to be out and about on the road? Standard rebuild? Feel free to PM me if you don't want this on the public forum :).

And luke for the short term I hope its not rebuild time but a stroker will be awesome in the long term.

Edited by Weezy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...