Jump to content
SAU Community

Recommended Posts

Can anyone help?

Ive a problem with my battery holding charge. Its a reasonably new battery and an expensive one, its about a year old and up until a couple of months ago. i could leave my portable fridge going all day without a problem running off the main battery supply but now i cant even leave it for 2 hours without it having trouble starting.

If i dont have the fridge in the car i have no trouble starting it day to day unless i leave it unstarted for 5 or 6 days +. The fridge isnt a real big one its only one of those ones that can heat and cool so it doesnt drain that much power.

Could my battery be stuffed already? or clould it be my alternator not providing enough charge but you wouldnt think so because it starts from day to day without any problem. Could it be anything else?

Any help would be good?

Edited by sturb25
Link to comment
https://www.sau.com.au/forums/topic/286639-problem-with-battery-holding-charge/
Share on other sites

Just got a battery check done and its all good. This has got me baffled!!!!

Probably voltage regulator! they tend to charge intermitently when on the way out. I would personally run a dual battery system if you are running a fridge then your primary battery would remain with enough charge to always start the stag thats what I run in my hilux its good piece of mind, but dont know where you would put second battery boot/etc. I use the red arc microprocesser to control my battery's it works well and not to expensive.You could also just use one of those jump start/powerpacks to run fridge! :domokun:

Probably voltage regulator! they tend to charge intermitently when on the way out. I would personally run a dual battery system if you are running a fridge then your primary battery would remain with enough charge to always start the stag thats what I run in my hilux its good piece of mind, but dont know where you would put second battery boot/etc. I use the red arc microprocesser to control my battery's it works well and not to expensive.You could also just use one of those jump start/powerpacks to run fridge! :P

Second all this, could also be the alternator bushes; I've had similar symptoms/problems before. I don't know if the bushes on the nissan alternators are like the standard bosch ones that just swap out with a phillips-head screwdriver, but it's a pretty cheap (~$20-ish?) fix if they are.

For a second battery, you might be able to get up to an 18 amp say gel cel to fit under the spare tyre cover in the boot. Especially if it's rated to work on its side.

Can anyone help?

Ive a problem with my battery holding charge. Its a reasonably new battery and an expensive one, its about a year old and up until a couple of months ago. i could leave my portable fridge going all day without a problem running off the main battery supply but now i cant even leave it for 2 hours without it having trouble starting.

If i dont have the fridge in the car i have no trouble starting it day to day unless i leave it unstarted for 5 or 6 days +. The fridge isnt a real big one its only one of those ones that can heat and cool so it doesnt drain that much power.

Could my battery be stuffed already? or clould it be my alternator not providing enough charge but you wouldnt think so because it starts from day to day without any problem. Could it be anything else?

Any help would be good?

Sound's like what I hear all day - everyday! (I work in roadside assist!)

Closed Circuit + time = dead bty!!!

Dual battery setup or Good roadside assist plan!

I only had my ipod on for a few minutes + the kids in the back with the dvd's = whinge whinge whinge (Not even monday YET!)

Presumably you have checked that there is no load/drain on the battery when your car is "off"? Obviously any alarm/central locking circuitry etc will still be drawing current but it should only be minimal.

I had an issue where my fog lights were left on (my old stagea - s2) - which flattened the battery very quickly. Before that I had no idea they even worked or how to turn them on - but they must've been flicked on accidentally the night before.

I'm assuming you've checked all the obvious stuff like this but thought I'd mention it anyway...

Presumably you have checked that there is no load/drain on the battery when your car is "off"? Obviously any alarm/central locking circuitry etc will still be drawing current but it should only be minimal.

I had an issue where my fog lights were left on (my old stagea - s2) - which flattened the battery very quickly. Before that I had no idea they even worked or how to turn them on - but they must've been flicked on accidentally the night before.

I'm assuming you've checked all the obvious stuff like this but thought I'd mention it anyway...

yeah nothing has been left on. Its been happening for a while now!!!

Recommend removing the positive terminal from the battery and connecting it via an ammeter/multimeter (initially set to the 10 amp range) when the key is out and everything is off to check the current draw. If it's anything more than perhaps 100 milliamps, you're going to have flat battery problems sooner or later. Even then it should probably be less than 30 milliamps, not sure.

the quickest way to check your alternator and starter motor is to get a multimeter set to volts and put accros battery mesure the volts then get someone to statr the car while you watch the multimeter.

It should not drop below about 10.5 volts if none of the acc are on now with the car running the alternator should be putting out around 13.5v to 14.2v.

if the volts drop below 10.5 when starting you could have a problem with the starter motor polling out wich means it is earthing its self so therefore all of your power will just be going into the earth rather than into turning the starter.

As for the battery put a charger on it ( about 10 amps) and see if you can get rid of some of the sulfation off the plates , wich is what happens when a battery runs flat.

I'm running a small SLA (Sealed lead acid ) battery wich has around the 600 cca but it also can be used as a deep cycle battery i.e run accessories.

I use it to run lights off the plug in the back for when i do call out's ( i work for a battery shop)

If you have any more problems just ask.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...