Jump to content
SAU Community

Problem With Battery Holding Charge

sturb25

By sturb25,
in Four Door Family & Wagoneers

 Share

Recommended Posts

sturb25 Proficient

sturb25

Posted
Posted (edited)

Can anyone help?

Ive a problem with my battery holding charge. Its a reasonably new battery and an expensive one, its about a year old and up until a couple of months ago. i could leave my portable fridge going all day without a problem running off the main battery supply but now i cant even leave it for 2 hours without it having trouble starting.

If i dont have the fridge in the car i have no trouble starting it day to day unless i leave it unstarted for 5 or 6 days +. The fridge isnt a real big one its only one of those ones that can heat and cool so it doesnt drain that much power.

Could my battery be stuffed already? or clould it be my alternator not providing enough charge but you wouldnt think so because it starts from day to day without any problem. Could it be anything else?

Any help would be good?

Edited by sturb25
Link to comment
https://www.sau.com.au/forums/topic/286639-problem-with-battery-holding-charge/
Share on other sites
rx7gt Contributor

rx7gt

Posted
Posted
Just got a battery check done and its all good. This has got me baffled!!!!

Probably voltage regulator! they tend to charge intermitently when on the way out. I would personally run a dual battery system if you are running a fridge then your primary battery would remain with enough charge to always start the stag thats what I run in my hilux its good piece of mind, but dont know where you would put second battery boot/etc. I use the red arc microprocesser to control my battery's it works well and not to expensive.You could also just use one of those jump start/powerpacks to run fridge! :domokun:

DaveB Mentor

DaveB

Posted
Posted
Probably voltage regulator! they tend to charge intermitently when on the way out. I would personally run a dual battery system if you are running a fridge then your primary battery would remain with enough charge to always start the stag thats what I run in my hilux its good piece of mind, but dont know where you would put second battery boot/etc. I use the red arc microprocesser to control my battery's it works well and not to expensive.You could also just use one of those jump start/powerpacks to run fridge! :P

Second all this, could also be the alternator bushes; I've had similar symptoms/problems before. I don't know if the bushes on the nissan alternators are like the standard bosch ones that just swap out with a phillips-head screwdriver, but it's a pretty cheap (~$20-ish?) fix if they are.

For a second battery, you might be able to get up to an 18 amp say gel cel to fit under the spare tyre cover in the boot. Especially if it's rated to work on its side.

32TAXI Experienced

32TAXI

Posted
Posted
Can anyone help?

Ive a problem with my battery holding charge. Its a reasonably new battery and an expensive one, its about a year old and up until a couple of months ago. i could leave my portable fridge going all day without a problem running off the main battery supply but now i cant even leave it for 2 hours without it having trouble starting.

If i dont have the fridge in the car i have no trouble starting it day to day unless i leave it unstarted for 5 or 6 days +. The fridge isnt a real big one its only one of those ones that can heat and cool so it doesnt drain that much power.

Could my battery be stuffed already? or clould it be my alternator not providing enough charge but you wouldnt think so because it starts from day to day without any problem. Could it be anything else?

Any help would be good?

Sound's like what I hear all day - everyday! (I work in roadside assist!)

Closed Circuit + time = dead bty!!!

Dual battery setup or Good roadside assist plan!

I only had my ipod on for a few minutes + the kids in the back with the dvd's = whinge whinge whinge (Not even monday YET!)

pixel8r Mentor

pixel8r

Posted
Posted

Presumably you have checked that there is no load/drain on the battery when your car is "off"? Obviously any alarm/central locking circuitry etc will still be drawing current but it should only be minimal.

I had an issue where my fog lights were left on (my old stagea - s2) - which flattened the battery very quickly. Before that I had no idea they even worked or how to turn them on - but they must've been flicked on accidentally the night before.

I'm assuming you've checked all the obvious stuff like this but thought I'd mention it anyway...

sturb25 Proficient

sturb25

Posted
  • Author
Posted
Presumably you have checked that there is no load/drain on the battery when your car is "off"? Obviously any alarm/central locking circuitry etc will still be drawing current but it should only be minimal.

I had an issue where my fog lights were left on (my old stagea - s2) - which flattened the battery very quickly. Before that I had no idea they even worked or how to turn them on - but they must've been flicked on accidentally the night before.

I'm assuming you've checked all the obvious stuff like this but thought I'd mention it anyway...

yeah nothing has been left on. Its been happening for a while now!!!

DaveB Mentor

DaveB

Posted
Posted

Recommend removing the positive terminal from the battery and connecting it via an ammeter/multimeter (initially set to the 10 amp range) when the key is out and everything is off to check the current draw. If it's anything more than perhaps 100 milliamps, you're going to have flat battery problems sooner or later. Even then it should probably be less than 30 milliamps, not sure.

25stagea Explorer

25stagea

Posted
Posted

the quickest way to check your alternator and starter motor is to get a multimeter set to volts and put accros battery mesure the volts then get someone to statr the car while you watch the multimeter.

It should not drop below about 10.5 volts if none of the acc are on now with the car running the alternator should be putting out around 13.5v to 14.2v.

if the volts drop below 10.5 when starting you could have a problem with the starter motor polling out wich means it is earthing its self so therefore all of your power will just be going into the earth rather than into turning the starter.

As for the battery put a charger on it ( about 10 amps) and see if you can get rid of some of the sulfation off the plates , wich is what happens when a battery runs flat.

I'm running a small SLA (Sealed lead acid ) battery wich has around the 600 cca but it also can be used as a deep cycle battery i.e run accessories.

I use it to run lights off the plug in the back for when i do call out's ( i work for a battery shop)

If you have any more problems just ask.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • JC71
      98 R34GTT 4k engine stumble

      By JC71 · Posted

      98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • r32-25t
      Why am I hitting a power wall with my stroked RB25?

      By r32-25t · Posted

      When you say your cams are 272/262 is that 272in and 262ex?
    • Kinkstaah
      Nismo GT Pro LSD configurations

      By Kinkstaah · Posted

      We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
    • PranK
      New Skyline will be RWD and manual

      By PranK · Posted

    • GTSBoy
      Nismo GT Pro LSD configurations

      By GTSBoy · Posted

      No, you're wrong, and you've always been wrong about this. The Nismo has 2 sets of openings. One is a real 2-way, and the other is a 1-way. There is no 1.5-way possible with the ramps that they offer. A real 1.5-way does exist. That Cusco stuff I posted is a prime example. If the forward drive ramps are, say 55°, and the overrun ramps are, say, 30°, then you will get about half as much LSD effect on overrun than you do on drive. It is real, it realy works. OK, you're slightly right. The Nismo has 55° and 45° ramps on the 2-way, so it does offer less LSD effect on overrun. But, I think that just means that they've (probably) sensibly established that you do not want actually equal LSD effect on overrun. You just want "quite a lot, but not quite as much as the drive LSD effect".
×
×
  • Create New...