Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

Would anyone be keen in for some Splitfire coil packs for there RB? Can get sets for $550 del to me straight from Japan.

Will usually take 2weeks max, depending how fast japs move. Would need money up front to.

Cheers

Would anyone be keen in for some Splitfire coil packs for there RB? Can get sets for $550 del to me straight from Japan.

Will usually take 2weeks max, depending how fast japs move. Would need money up front to.

Cheers

If only you had posted this a few days ago, my mate just ordered a set :D

Nah, hit a brick wall with wiring after I did all the ones in this RB-S13 guide I found and the c*nt still didn't start.

have you tried yelling at it? or hitting it?

YOU FUCKING BEAUTY!!!

The silvia runs!! Called up Decs from Garage 7, he's like ya gotta change these wires and it'll work. Made said changes, turned the key and sure enough that sweet, sweet RB sound filled the air...

... as well as the not so sweet sound of the loose harmonic balancer raping the timing belt cover something fierce :)

Oh well, it runs and that's a fking win in my book - now for some celebratory beers!! ;)

Skids when the harmonic balancer and snapped stud in turbo is fixed ;)

YOU f**kING BEAUTY!!!

The silvia runs!! Called up Decs from Garage 7, he's like ya gotta change these wires and it'll work. Made said changes, turned the key and sure enough that sweet, sweet RB sound filled the air...

... as well as the not so sweet sound of the loose harmonic balancer raping the timing belt cover something fierce :)

Oh well, it runs and that's a fking win in my book - now for some celebratory beers!! ;)

Skids when the harmonic balancer and snapped stud in turbo is fixed ;)

requesting 1 x invite for festivities

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...