Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

if you're not labouring it, use 5th

ive gone back to that in my fourby, gets me an extra 100km out of a tank easy just doing that

+1. I'm almost always in 5th at 60 km/h and and when it's flat I often go through 50 Km/h zones in 5th too. :)

+1. I'm almost always in 5th at 60 km/h and and when it's flat I often go through 50 Km/h zones in 5th too. :)

if i try to use 5th at 60kmh, the car nearly stalls....

1st = 0-96km/h

2nd = 133km/h

3rd = 175km/h

4th = 205km/h

5th = 2xxkm/h

Factors Affecting Fuel Economy

Fuel economy is affected by a vehicle's size, weight, aerodynamics, fuel delivery system, engine type and transmission type. These values remain constant for a specific vehicle.

There also are many variable factors. As mentioned, the heating value of the petrol is one. In addition, fuel economy is affected by weather conditions, air conditioner use, road conditions, the route driven, driving speed and driving style. And it is affected by the mechanical condition of the car - engine tune, wheel alignment and tyre pressure. Some of these non-petrol factors have the potential to cause substantial changes in fuel economy. The table below shows a list of average and maximum effects published by the United States Environmental Protection Agency (EPA).

Click for image

Winter-related factors can combine to lower fuel economy 20% compared to the summer. Rain or snow on the road offers more resistance to the tires. It may also require the driver to slow for safety to a less fuel-efficient speed. In cold weather, a richer air-fuel mixture is required to start and warmup the engine. And much of the warmup is done at idle because of the need to defog or defrost the windows. Also, in many vehicles, the air conditioner is operated to assist defogging. More energy is required to overcome the resistance created by the higher viscosities of cold lubricants - engine oil, transmission fluid, and differential lubricant.

Short trips are worse for fuel economy than long trips because a cold engine uses more fuel than a warm engine and because of the energy required to overcome the resistance of cold lubricants. Traffic jams and bumper-to-bumper driving also extract a heavy toll on fuel economy.

http://www.chevron.com/

^^

Conclusion

We don’t think any of the points made in this article are groundbreaking. Bluntly, they are not. But if you select the car carefully on the basis of the real needs it must satisfy, keep it well maintained and drive it well, you will be getting the best fuel economy possible in your driving circumstances.

No shit! :)

that article doesn't mention the use of 5th gear at 60-65 km/h....

uhm... fuel consumption isnt directly effected by revs, load has more of effect.

Revs has something to do it for sure, the lease cars i used to get with the trip meters in them that show instant fuel usage backs that up, driving down heaslip road doing 90 it'd be showing me using more fuel in 4th at higher revs then 5th in lower revs...But Steve has also hit the nail on the head with that post he's put up sums it all up really

Was walking down hindley around 3am this morning. I see the undercovers 4wd, cops jump out to help with this fight. One guy who was involved in the fight runs off towards me and 5 cops chase after him down hindley. My mate kicks the guy in the leg, slows him down abit, cops still chasing him, tackle him from behind and the guy goes straight to the ground. Everyone cheers.

Was fun to watch this guy get decked.

Thats my exciting night :(

LAWL i saw that i was crossing the road all the cops ran out the 4wd n ran past me n ma mate haha i thought someone cleaned the guy up be4 the cops did becoz everyone was clapping n cheering hahaha oh god it was funny!!

epic fail for the guy fleeing the scene :)

lol, not a bad score at all. considering you can buy the same seat in the same condish for about 10 times that.

shame that rail i pulled off it is a passenger rail. might just flog it.

uhm... fuel consumption isnt directly effected by revs, load has more of effect.

+1, my old man told me that 5th should be reserved for anything over 80, and that goes for the majority of cars

you need a certain amount of revs to cycle the oil system to the required pressure, I would never drive 60kph in 5th unless it was downhill (in which case the drivetrain is not under load)... the gear ratios in a GTR are quite nice imho, I wouldnt want to change the ratios for a daily driven car... on my weekend hills run, i very rarely used 5th gear and the fastest we went was 115kph, so I kept it in 4th for most of the way, and the entire 2 hour run took just a tad over a quarter tank... most of the time the car was in 3rd doing 4000rpm around corners, so I wasn't being gentle, and yet it took much less fuel than I estimated

-D

woo got my seat from JMS, little bit haggered but nothing i cant fix up. not bad for $49 :)

if you change your mind and your wanting to off load it ill give you 100bux for it how it is.

im keen to use it in a ps3, steering wheel setup lol

if not ill just keen using the ebay jobby but fixed back in your living room sucks wang

yeah RB20 isn't too fond of doing 50k in 5th, will just handle 60 aslong as there isnt any hills or sudden accelleration required, but 4th fits the bill fine, even 80 in 4th sits fine. Will be interestering to compare the new 25/25 engine/gearbox combo...

if you change your mind and your wanting to off load it ill give you 100bux for it how it is.

lol. this is where i up the bid to $150... could use a passenger seat. :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I thought I'd come back and add something I JUST learned. A Toyota LandCruiser with a 1HZ, mates perfectly with a bottle of Nulon brake fluid. As in, it perfectly screws in. Great make shift funnel when you cut the bottom of it off. This may work for your Corolla.   Unfortunately, tipping a 10L drum is much harder than a 4 to 6L bottle, and they no longer include the easy pour tap which was just perfection to use previously.  
    • Guys since i bought r33 gts25t coupe 1994 automatic a/t(manual swap 350z gearbox)  all i got is problems, always problems. Lets start with that when i turn key into ignition(ON) fuel pump doesnt always works. Sometimes i have to turn key twice Off/on/off/on until it primes. Its new, dw300 - 340lph. My gearbox broke so i did gearbox swap, install different intake manifold, injectors and i take pipes. Car was sitting in garage for more than half a year. I did assembly all not that long ago and when i turn ignition cant hear prime. All of sudden it stopped working. Theres many videos on YouTube how to make relay mod on r33 straight from battery so i did and it doesnt work! 😰 30 - battery positive  87 - positive from fuel pump to relay 85, 86 - one of two wires from original fuel pump wires(light blue, grey) and it didn’t work. so I check on ignition and took original BLUE relays wires from trunk, next to fuses. (I believe it’s IGN+ and ECU pin 18. it didn’t work…  tried connecting (IGN+ from og relay) and (ECU 104 from 1of4 FPCM wires) to my new relay 85/86 and it didn’t work.  I unplug FPCM. Didn’t work. im thinking what’s wrong   fuel pump is working, if I leave IGN+ on 85 and 86 straight to ground it works but it’s just nonstop. Since it getting constant 12v after key in ON. light blue wire gives me 6-8v.  so how this should be connected? What causing ECU not giving — on pin? Or I did sth wrong and that’s why it doesn’t work? I need negative signal on ECU that control fuel pump. What this should be?
    • You can use your VIN to look up the factory part number somewhere like amayama, and then look to order new if necessary. https://www.amayama.com/en/genuine-catalogs/nissan Depending on price you might want to rebuild instead. @GTSBoy I had an interesting insight into US market parts when the Titan rear calipers were sticking. New calipers were dirt cheap, about 20% more than a rebuild kit....they are just considered throw away maintenance items
    • Funny, but really not funny. Thank god (most) f the world has moved on since then
    • Lots of votes for driving onto a plank first; that is the quickest way I've found, 25mm is enough for my case but that will vary by car It also depends where you are going for. On the 32 I can get to the rear diff with my floor jack if I do that end first, and get it up on stands. Then I lift the front from either front tow hook as high as needed, also onto stands. Sometimes I need a small lift on the other tow hook to get it level enough If I do the front first I can't get to the rear diff because of the angle of the car Other options are getting to the front mount of the rear subframe from in front of the wheel (if only lifting one side, or just do both which is a bit of a pain compared to one lift from the diff), or also the gearbox cross member mount on the driver's side if you are  just trying to lift the driver's side. I This is the jack I use; it says 75mm clearance but of course that is only on the lower section so if you have to reach too far in like the diff you still get stuck. https://www.snapon-bluepoint.com.sg/category/Floor-Jacks/product/Floor-Jack,-2-Ton-Low-Profile
×
×
  • Create New...