Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

lol i got the coin but not using it for another car unfortunetly as my new job will be sending me off shore and around australia and maybe the world so will be getting a house and renting it out

nothing wrong with ca's man, pulls very hard, very healthy and strong and much better then an sr (sounds better too)

Edited by Import S13

.. its running but shes starving for fuel... its killing me..... tomei(whoever makes it) fuel pump isnt doing what it should so looks like ill be getting it back severely detuned.. untill i can free up some more money to go one in tank and twin externals + surge tank... sir dale stirls will be helping me through the fueling journey and and were gonne setup something than can hopefully munge on e85.... i was once told patience is a virtue and im truly learning what that means now.....

post-27156-1275062571_thumb.jpg

post-27156-1275062586_thumb.jpg

post-27156-1275062601_thumb.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...