Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

he sure if gotta go down a long drive way then off to the left.

Offtopic: i cant find a definate answer on here atm hope someone can help whats the lowest height you can go legally in SA?

Lowest part of the car cant be lower than 100mm from the ground, and eyebrow height must not be lower than (insert R34 minimum ride height here).

I think most of the pro/well known guys like pickering don't bother with 'public' drift pracs anymore cause they rock private days and, more recently, jap matsuri's, so I'm lost as to why he bothers having a whinge when it doesn't affect him/them at all.

Edited by AndrewJZX100

Just watched the latest Top Gear... had a tribute to Senna. In a word, amazing. Brought a tear to my eye. Anyone with a single drop of motorsport blood in their veins should watch it, incredible man

i just went and ordered some parts (on shaun's recommendation for now...........the whole "if it aint broke dont attempt to tear it apart" theory works for me :D)

stupid me cant remember if it was out of stock BEFORE i ordered it haha

http://justjap.com/store/product.php?produ...at=0&page=6

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...