Jump to content
SAU Community

Recommended Posts

yeh i think i went in there to get some ciggies or something cant remember. i am just always around the area like randwick coles and parking nearby to go to uni and anzac parade for dinner.

im in final year studying law so hanging around lower campus. how about you?

2nd yr mechanical engineering, im usually hanging out near quad or roundhouse, should meet up and have a chat sometime

spotted a silver R32 gtst on king georges rd around 7ish, then turned on canterbury rd

and a silver r34 gt-t on king georges rd at beverly hills, plates LH-00-HS i think, i was next to him for quite a while, :yes: but in my sisters blak integra :)

Spotted Sam, Corinne, Steven, Jase, Dave, Taran and Wayne at Hard Rock Cafe, then IMAX then Max Brenners last night :P and also spotted a few dodgy SAU'ers hiding in the back of an R31 wagon..... :yes:

Spotted Hasey on liverpool st last night...

I cut you off in a beige coloured civic :stupid:

hahahaha pitty you didnt see me on macquarie street getting defected by the riot police.. that was funnier!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...