Jump to content
SAU Community

Recommended Posts

you're gonna be driving a lancer ?

LMAO :D

Evo VIII is faster around Tskuba than a R33 GTR, both in stock trim :D

Either way, driving a lancer has to be better than driving a mazda 121 :lol: :lol: :lol:

So ?

I can still pay you out tho :D

And who said my car is stock?

Dont worry, im 'upgrading' also

haha, lancer might not be stock either :) lol, this is a stupid discussion anyway :D

What you upgrading to?? R34?

Edited by TommO

spotted a red 33 on corner of showground and windsor rd.. i waved.. the chick driving was a lil confused and only half waved!! :)

also spotted a silver 32 gtr... plates GTR something... beeped and got a wave in return.. this was near eastern creek! :wavey:

also spotted some nice lines at ec ;) DIMZILA (sp?) stands out... very nice car dude!!!!! sounded awesome! :)

also spotted brett and adrian causing trouble :)

Weirdest thing yesterday; thought I saw my own car driving around in my neighbourhood! White R34 GTT with Impuls....

Differences:

* Car was stock except for exhaust

* Car was riding at normal height

* Rear wheels kinda skinny :)

* It had a sexy sun-roof

Spotted outside of Col Crawford BMW... if you're on here mate, let us know we'll meet up sometime.

Also, another R34 GTT with black tail-light surrounds, always spot you around the Balgowlah and Dee Why area... you on here too?

spotted ?REL15H? i think that's b-man.. saw u at the last sec so i just barely got half a wave in lol (i was the blue r32 gtr on mowbray rd)

spotted a nice looking white r34 gtr plates "IFONLY" on the M4 on my to EC.. didnt even bother to look even tho they weren't going fast..

sic kents <_<

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...