Jump to content
SAU Community

Recommended Posts

Don't worry about playing with the ECU. As long as you are careful and you have a little soldering skill there will be no problems.

Just be sure you disconnect the negative terminal before touching the ECU, and make sure the joins are all insulated properly. The vehicle specific wiring diagrams can be obtained from the Apex-USA website.

Link to comment
https://www.sau.com.au/forums/topic/29300-avcr-install/#findComment-601750
Share on other sites

Hey Gojira.

Thanks for that. It should help a fair bit. The only one that i could find anywhere was one for a GTO, and that wasn't very helpful.

Thanks too Redbaboon, i wasn't too sure where to look for the wiring diagram. I should be ok with this. I'm going to try and mount it somewhere that is not all that obvious.

I was thinking of putting into the din pocket below the my radio. I'll just have to try and get one with a door so you can't see it.

Link to comment
https://www.sau.com.au/forums/topic/29300-avcr-install/#findComment-601966
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...