Jump to content
SAU Community

Recommended Posts

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

i was thinking of a vent in the bonnet above the pod filter as well, however the main problem then is water getting into ur engine bay and if driving ur induction system! would need to have like a drainage system or like a vent cover so in the rain u can drive, but no cold air :cheers:

I wouldnt know which one is the loudest, but heres a comparison somebody did between different filters. Apexi was the best :D

http://www.mkiv.com/techarticles/filters_test/2/

I have an Apexi pod, but I found that unless you're using a cold air partition, the HKS gives you noticably more power. I *think* this is because it faces more to the front and has more of a face to the incoming cold air, whereas the Apexi pod can suck in hot air from the sides. But when I put the box in, the power was pretty much the same for both (I couldn't tell the difference anyway).

If you didn't want a cold air box/partition, I would probably prefer the HKS filter or another one of a similar shape. Although then you have to worry about the particle filtration, which was my main concern when choosing the Apexi pod.

  • 1 month later...

I've got a Blitz SUS LM on mine, and yup, its friggin loud. You can hear it sucking, even when slightly cruising. With the window down its probably the loudest thing you can hear in my car! Its kinda cool, and annoying at others - but its staying on.

So if a cop pulls any of you over, and pops your bonnet, and sees a pod/s they will defect you right?

I had a large K&N pod on my old car (Alfa Romeo) but it was on the end of a pipe which I had custom made to sit down very low away from the engine and close (but not too close so that it sucked up water from puddles in the rain) to the road. And the cops would never have found it because you couldn't see it but damn could you hear it!!!!!!

I want to install duel pods in my RB26 but I don't want to get defected!

Guest RedLineGTR

Best Bet are get a photo of it possbily and post it in the for sale section (parts) and most likly some one will buy it u just have to figure out a price to sell it...how much u ask?? i have no idea. I have found that people have still been buying them, so all i can say good luck.

Cheers Rob

Guest RedLineGTR

Also those tests are with a high concentration of particles and toxins, and it never gets that bad on "normal" roads, but to stop the really microscopic particles u can’t use foam at all. Best bets are for a Mesh type filter wet or dry, out of the tests I would go for the apexi one but i personally want one that i can clean nothing is clear forever and will eventually restrict flow, I myself have a k&n filter with the light oil it has and the Mesh type filter I’m pretty sure its doing a good job (I don’t believe 100% those test u don’t know if they are new etc). My 2 Cents.

For those running the Blitz Sus LM are there any temp problems and how often do you clean them, if at all?

I'm thinking of buying one, but i can't find the Stainlees steel one. Only the..er..non stainles steel. hehe

The review, earlier, shows that it does not filter that well. Has anybody had any filtration problems while using a Pod?

I currently have a K&N panel filter in my standard air box. You can hear the induction noise from the inside and a slight BOV sound, but it's not that loud. If the radio is on all you hear is the exchaust......and the radio of course!! :wassup:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'd be worried about having to parallel park a boat like that. Magnificent car though.
    • This car has run before on this z32 ecu can get the part number for you, I have tried with no AFM it didn’t change anything, I compression tested today 140-150 across all 6 cylinders, also set fuel pressure to 43psi. The only weird thing was cylinder 1 plug was black and fouled other 5 cylinders were just wet with fuel. Spun cas by hand and confirmed injectors are clicking 
    • Since you came here to ask for help, have you thought about answering our questions, that might help us lead you to why it was skipping, or have you given up on getting advice?
    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
×
×
  • Create New...