Jump to content
SAU Community

Recommended Posts

Hey everyone. I had a search on the forums. Found a couple topics sort of on the same brain wave but no exactly what I'm after. So forgive me if this has been coveren n just past me a link to where the topic is :blush:

ok...

My car has serious "power delivery" issues. Down low, as boost begins to come in the car will hesitate n stutter like mad (has better and worse moments. sometimes won't happen = rare though) and the car feels realy "bogged down" and hesitant. Not the smooth kind of "I'm running a bit rich" hesitant that creates flat spots either. Once the revs start climbing the initial "rapid/harsh" kind of stutter dissapears and is usually replace with a more minor stutter (still 100% noticeable) right through to redline.

The low rpm initial symptom happens practicaly always and can only be avoided if I let the revs wind up a bit (bout 3-3.5k) before putting the boot in (to which I will get one short sudden stutter before revs climb nicely) to which I'm then greeted with the next stuttering feelinG at higher rpms probably every 2 out of 3 times I attempt to let the revs climb for longer then about a second or 2 after the initial stuttering. (following so far? Lol)

I've tried to monitor the boost as this happens and it appears to be climbing steadily. And the boost doesn't seem to cut when the stuttering starts.

Ok my setup. Nothing fancy.

It's a r33 gtst s2 manual.

Pod.

hks cat back (or just rear muffler not sure,looks like a catback, although pipes seem a bit small)

Gizzmo digital boost controller (10psi)

Splitfire coils

Ngk iridium plugs pre gapped to .8. Heat rating 6.

Rest is stock. Now the coils n plugs I did last week to try rectify this problem as my mechanic took a quick spin n suggested it feels like a coil or a plug. Having replaced a coil earlier on I thought screw it I'll get the whole thing replaced.

Obviously to no avail which is why I'm here.

Before I waste any money taking it to my mechanic/tuner has anyone got any thoughts. Unfortunately this is ruining my enjoyment of my line :)

Thanx in advance.

Tys

Link to comment
https://www.sau.com.au/forums/topic/295232-choppy-power-cutting-etc/
Share on other sites

If you're running a POD, it could have a film of oil on the AFM. Try taking the AFM out and spraying the thin wire thoroughly with CO contact cleaner.

ok mate will do. Thanx for the suggestion.

Is it likely to be that dirty as I'm running a dry pod setup?

Thanx again

Tys

How long has this been going on for?

since I had my boost contoller put in.

When it's set at 10psi preset I feel it the most. When I put it on 7psi preset I feel It less, or much less severe I should say, still as frequent. Howeever as increasing boost increases

fuel and changes a bunch of engine aspects, and as the boost appears to be holding consistantly I seem to think it's not a boost issue.

since I had my boost contoller put in.

When it's set at 10psi preset I feel it the most. When I put it on 7psi preset I feel It less, or much less severe I should say, still as frequent. Howeever as increasing boost increases

fuel and changes a bunch of engine aspects, and as the boost appears to be holding consistantly I seem to think it's not a boost issue.

having said that it may have been happening before my controller was put it, and I may not have noticed. As I seethe boost higher higher (7,8,9,10 I have four presets) the symptoms get worse.

turn the car on and then tap the AFM or play with the plug leading into the AFM, if you experience the same stuttering probs normally means its a lose solenoid in the AFM...my car was experiencing the same problems and it was an AFM issue, had it replaced and shes running smooth now.

turn the car on and then tap the AFM or play with the plug leading into the AFM, if you experience the same stuttering probs normally means its a lose solenoid in the AFM...my car was experiencing the same problems and it was an AFM issue, had it replaced and shes running smooth now.

ok thanx I'll give both things a try. Ur suggestion and the other of checking to make sure AFM wire is clean. N I'll report back. Was ur problem mainly under load? Cos this is. Idle is fine.

Cheers :rofl:

ok thanx I'll give both things a try. Ur suggestion and the other of checking to make sure AFM wire is clean. N I'll report back. Was ur problem mainly under load? Cos this is. Idle is fine.

Cheers :(

Okm started it up, and tried messing with the AFM, tapping it, fiddling with the loom, the clip, giving it quite a bit of shake, more than id hope would be going on under normal driving onditions, n not so much of a hiccup.

i took off the pod n tried to have a look at the state of the wire, could only look through the mesh, and wasnt sure what a clean AFM wire should look like.. im in the process of trying to find an image on here showing the difference between a clean n dirty AFM wire...

any help on what a clean wire should look like.. as i couldnt see clearly and it looked like there was a bit of a buldge in the middle of the wire, is that grime, or a little sensor??? lol

Annddd any other suggestions to the cause of this problem... many thanks in advance...

Tys :)

Also need to mention... when i slowly ease on the throttle, it pulls nice n smooth.. the further down i have the throttle the more it starts to hiccup etc... esspecialy at low rpm under load.... thanx again

edit: i did mention it already in the first post :smackhead:

Edited by ShiftyTys
Don't worry abuot looking to see if it's clean.

Unbolt and clean it.

so completely unbolt and drown in CO contact cleaner?

any special precautions? (allow to dry? dont spray directly on wire, etc etc?)

thanks

so completely unbolt and drown in CO contact cleaner?

any special precautions? (allow to dry? dont spray directly on wire, etc etc?)

thanks

Take it out completely filter and all piping off...

Spray the wire as much as possible. That's the sensor, you want it clean.

Let it dry, will only take a few mins to be 100% dry.

Only precaution, keep the stuff off your hands/skin. It's not bad bad to get it on, but your hands will get cold (And I believe it is carcinogenic too, but meh)

yup.

ahh ok. Lol. Went in a few times n spoke to him. Then he left n spoke to ummmm I duno mark I think his name was. N he gave me a card for status tuning. N I noticed it in ur sig lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...