Jump to content
SAU Community

Recommended Posts

I called K-Sport a while ago and asked about replacement rotors for there kits (330mm kit).

It was just for the rotor. Would have to re-use the hat.

Front pair where $800. This was around 6 months ago though. Not sure if it still stands.

Cheers

Yeah I spoke to just jap and they said about $950 for the 356's but maybe cheaper coz they were importing their own replacement rotor. about $850

  • 2 weeks later...
  • 11 months later...
  • 3 years later...

Bumpity bump.

I've been pricing 356mm rotors for D2/G4/Ksport and they're coming back at around $950, similar to the pricing above (that may include hat and bolts which i dont need - waiting for clarification about that). Duncan's DIY says "A pair of rings (~$400)"

http://www.skylinesaustralia.com/forums/topic/414681-diy-replacing-pads-and-rotors-on-d2g4attkd-etc-8-piston-brakes/

Where did those $400 rings come from?

FWIW Justjap dont carry D2/G4/Ksport anymore (I bought my G4 kit from them) and say the attkd stuff is different.

I got them from Just Jap...and while I wouldn't argue if they say ATTKD are not the same, I'm very surprised if they are not interchangeable. Judging from the other posts in here it might have been a special deal on price though, and it was 300 not 356mm

You can always swap to a DBA or similar disc, or go to ATTKD rotors+hats which I'm sure would fit in the calliper unless they have used a different offset.

I did some digging after your comment about the ATTKD stuff, and found JJ have the pair of 356x32mm ATTKD rotor rings for $500, (330s are $250) and the website also says;

"356mm Front Brake Rotor Set (Hats Not Included) To Suit: ATTKD - 356mm Front Brake Rotor Set Other Manufactors [sic] That Will Suit: K-Sport D2 AP Racing"

So their staff dont even read their own website!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...