Jump to content
SAU Community

Recommended Posts

When you turn the key to the ON position can you hear the fuel pump priming?

priming as in that buzzin sound it does? ugh i didnt take notice when turned the key. but i tried just then and i didnt hear the buzzin it makes :blink: does that mean my fuel pump is buggered..

would anyone have an old fuel pump they are not using so i can borrow and try it in my car to see if thats the problem. if it is im happy to buy it off you so i can drive my baby to get a better pump

Edited by LiL_JeT
  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

It could be the pump or it could be the relay. best to get an auto elec to check it out unless you can find a spare pump easy.

where abouts is the relay located for the fuel pump? i cant find it.

priming as in that buzzin sound it does? ugh i didnt take notice when turned the key. but i tried just then and i didnt hear the buzzin it makes :devil: does that mean my fuel pump is buggered..

would anyone have an old fuel pump they are not using so i can borrow and try it in my car to see if thats the problem. if it is im happy to buy it off you so i can drive my baby to get a better pump

by the sounds of it you fuel pump might have gone mate.....time for a upgrade me thinks :)

there are a few aftermarket ones around.....

r34 has a different wiring stuff thingo (sorry don't know how to explain it properly) wiring socket maybe? but if the dude gives you the wiring stuff as well just need to tap it on your standard one.

are you talking about the whole assembly how the harness is different? or the pump itself? but in any case. a r34 gtr pump will fit , yes or no? lol dont wana be buying something i'll never use

^^ Agreed & going to give you more power potential too.

Also if you get a second hand pump, don't be surprised if you have to pull that bugger out again only 12 months (or 12 minutes) later because it was already nearly worn out.

either pumps are decent upgrades.....i got mine off Habi-bay and it seems to be working well so far....has supported 250 rwkw without any probs

how much does it cost to get a pump fitted? for example the bosche 040 and anyone you recommend?

how much does it cost to get a pump fitted? for example the bosche 040 and anyone you recommend?

Most workshops will charge you per labour hour which is normally around the $80 mark.....i had my fuel pump and boost controller fitted for i think $80 and a dyno run to see if it all worked fine and to tune the EBC.....all and all it came up to $80 as it took them roughly 1 hour to do lol...

Call and find what workshops will charge you mate.....

workshops up north: pitlane performance, smooth garage, boostworx, morepowa, fours n more, boosting oz

search them up and call em mate

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Started sifting thru my brakes to decide which ones I will run on Clem   Made me think I should just put them all on Silver...for when brake fade just isn't an option   Should be able to bump rotor up from 343x32 to 348x36 off Supra. Not sure if the Supra annulus is right for the Alcons or APs but trying g to find a used Supra\M4 rotor to test fit The Alcons seem to gain 1-2mm clearance which all helps  
    • So car is getting a few mods to the cage and some jacking points welded in Meantime Ol Silver gets a new gearbox and shiny clutch.  Old Box is being set aside for Clem  
    • Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
×
×
  • Create New...